Cupra BORN 2022 - Anti-Theft Alarm

Opening and closing
97
Anti-theft alarm
Locking the vehicle after an airbag is trig-
gered
When an airbag is triggered as a result of
an accident, the vehicle is fully unlocked. De-
pending on the extent of the damage, the ve-
hicle may be relocked after the accident as
described below:
●
Switch the ignition o.
●
Open the driver's door and close it again.
●
Lock the vehicle.
Note
If the 12-volt vehicle battery has little or
no charge, or the vehicle key battery is al-
most or entirely out of charge, you will prob-
ably not be able to lock or unlock the vehi-
cle with the Keyless Access system. The ve-
hicle can be unlocked and locked manually
›››page99.
Note
If there is no vehicle key in the vehicle or
the system does not detect it, a warning will
be displayed on the instrument cluster. This
could happen if any other radio frequency
signal interferes with the key signal or if the
key is covered by another object, e.g. a metal
case.
Anti-theft alarm
Description
Depending on the equipment, the vehicle may
be tted with an anti-theft alarm.
The anti-theft alarm monitors the doors, front
bonnet and rear lid.
The anti-theft alarm system activates automat-
ically when the vehicle is locked.
If the vehicle is not opened electronically with
a valid key, the alarm triggers and emits audio
and light signals for a maximum of approx. 5
minutes.
When is the anti-theft alarm triggered?
●
If a mechanically unlocked door is opened
with the vehicle key.
●
If the front bonnet is opened.
●
If the rear lid is opened.
●
If an invalid vehicle key is used.
●
If there are movements inside the ve-
hicle (in vehicles with interior monitoring
›››page97).
●
If the vehicle is lifted or towed (for vehicles
with an anti-tow system ›››page97.
●
If the vehicle is transported on a ferry or by
rail (in vehicles with an anti-tow system or inte-
rior monitoring ›››page97).
●
If the 12-volt battery is disconnected.
●
If the window is broken.
Switching o the alarm
●
Unlock the vehicle with the vehicle key un-
locking button .
●
Grip the door handle.
●
Switch the ignition on. Please note: to turn
on the ignition, place the vehicle key in the
area provided for it to perform an emergency
start ›››page146.
Note
If the 12-volt battery is low or discharged, the
anti-theft alarm will not work properly.
Interior monitoring and anti-tow
system
If movement is detected in the vehicle interior
while the vehicle is locked, the interior moni-
toring triggers the alarm.
If it detects that the vehicle is being lifted, the
anti-tow system triggers the alarm.
Switching on the interior monitoring and the
anti-tow systems
●
Lock the vehicle. When the anti-theft alarm
is activated, the interior monitoring and the
anti-tow system are as well.