Cupra BORN 2024 - Window Anti-Trap Function

Opening and closing
107
Window controls
The comfort opening settings can be changed
in the infotainment system's Vehicle menu.
One-touch opening and closing
Automatic raising and lowering fully opens and
closes the windows. It is not necessary to press
and hold the appropriate window button for
this purpose.
For the automatic raising function: pull the
button for the corresponding window upwards
until it reaches the second position.
For the automatic lowering function: push the
button for the corresponding window down-
wards until it reaches the second position.
Stop automatic movement: push or pull on the
button of the corresponding window.
Resetting the automatic raising/lowering
function
If the 12-volt battery is disconnected or dis-
charged when the windows are not completely
closed, the power window automatic raising
and lowering function deactivates and has to
be reset:
●
Switch the ignition on.
●
Close all doors and windows.
●
Pull the corresponding window button up-
wards and hold it in this position for a few sec-
onds.
●
Release the button, pull it up again and hold
it in this position. This resets the automatic
raising and lowering function.
The function can be reset for a single window
or for several windows at the same time.
WARNING
Observe the safety warnings ››› in Intro-
duction on page102.
●
Improper use of the power windows can
cause injury.
●
Never close windows carelessly or in an un-
controlled manner, as this could cause seri-
ous injuries to you or third parties. Therefore,
make sure that no one is in the way of the
moving windows.
●
If the ignition is switched on, electrical
equipment such as the power windows could
activate, which can cause injury.
●
The vehicle doors can be locked with the
remote control key, making it diicult to get
help in an emergency.
●
Therefore always take the key with you
when you leave the vehicle.
●
The power windows are only deactivated
when the ignition is switched o and one of
the front doors is opened.
●
If necessary, deactivate the rear power
windows with the safety control. Make sure
that they have actually been deactivated.
●
For safety reasons, you should only unlock
and lock the vehicle with the remote control
key when you are approximately 2 metres
away from the vehicle. When pressing the
lock button, always monitor the movement
of the windows to avoid accidents. Releasing
the button immediately interrupts the clos-
ing process.
Note
If the window is not able to close because
it is sti or because of an obstruction,
the window will automatically open again
›››page107. In this case, check why the
window could not be closed before trying
again.
Window anti-trap function
The roll-back function reduces the risk of in-
jury when the power windows close.
If a window encounters resistance or an obsta-
cle when closing, it will reopen immediately
›››
.
●
Check why the window does not close.
●
Try closing the window again.
●
If the closing process is interrupted again,
the anti-trap function stops working for a few
seconds.