Cupra BORN 2024 - Adjusting the Headrests; Removing and Fitting the Headrests

114
Seats and headrests
NOTICE
When assembling and disassembling the
headrests, do not allow them to come into
contact with the vehicle's ceiling liner, the
back rest of the front seat or other parts of
the vehicles. Any such contact could damage
the vehicle.
Adjusting the headrests
Fig.87 Rear headrest: adjusting the
headrest.
Adjusting the height of the headrests
●
Grab the sides of the headrests with both
hands and push upwards to the desired posi-
tion. To lower it, repeat the same action, press-
ing the button on the side
1
›››Fig.87.
●
The headrest must lock correctly in one po-
sition.
Removing and
tting the headrests
Fig.88 Rear headrest: removal.
Removing the rear headrests
To remove the headrest, the corresponding
backrest must be partially folded forward.
●
Unlock the backrest ›››page112.
●
Move the headrest upwards to its highest po-
sition.
●
Press button ›››Fig.88
1
, while simultane-
ously pressing on the safety hole
2
with a at
screwdriver a maximum of 5 mm wide, and re-
move the headrest.
●
Move the backrest until it engages properly
››› in Folding down and raising the rear
seat backrest on page113.
Fitting the rear headrests
To mount the external headrests, the corre-
sponding backrest must be partially folded for-
ward.
●
Unlock the backrest ›››page112.
●
Insert the headrest bars into the guides until
they are heard to engage. It should not be pos-
sible to remove the headrest from the back-
rest.
●
Move the backrest until it engages properly
›››
in Folding down and raising the rear
seat backrest on page113.
WARNING
Remove the rear headrests only when it is
necessary to t a child seat. After removing a
child seat, ret the headrest immediately.