Cupra BORN 2024 - Page 124

122
Lights
●
If the windscreen is damaged in the camera's
eld of vision.
●
If the camera's eld of vision is misted up,
dirty or covered by a sticker, snow or ice.
●
If the camera is damaged or if the power
supply has been cut o.
WARNING
The comfort features of the main beam assist
must not lead you to take any risks. The sys-
tem is not a replacement for driver concen-
tration.
●
You must always control the main beam
yourself and adapt it to the light, visibility and
traic conditions.
●
The main beam regulator may not recog-
nise all driving situations correctly and may
operate with limitations in certain circum-
stances.
●
When the camera’s eld of view is dirty,
covered or damaged, the operation of the
main beam regulator may be aected. This
also applies when the vehicle’s lighting in-
stallation is modied, e.g. when additional
headlamps are installed.
NOTICE
To avoid aecting the operation of the sys-
tem, take the following points into considera-
tion:
●
Clean the eld of vision of the camera reg-
ularly and make sure it is free of snow and ice.
●
Do not cover the eld of vision of the cam-
era.
●
Check that the windscreen is not damaged
in the area of the camera’s eld of view.
Note
●
The headlight asher can be turned on and
o manually at any time with the turn signal
and main beam lever ›››page120.
●
If there are objects that radiate light in the
camera's area of inuence, e.g. a portable
navigation system, this may aect the opera-
tion of the main beam assist system.
“Cominghome” and “Leav-
inghome” function (exterior ori-
entation lighting)
The “Cominghome” and “Leavinghome”
function lights up the vehicle’s immediate sur-
roundings when getting into and out of it in the
dark.
This light is automatically controlled by a light
sensor.
Turning on the “Leavinghome” light
●
Unlocks the vehicle (if the automatic dipped
beam function is switched on and the light
sensor detects darkness).
Turning o the “Leavinghome” light
●
It turns o automatically once the lights o
delay time has elapsed.
●
OR: lock the vehicle.
●
OR: press the light control as many times as
necessary until the instrument cluster displays
the setting .
●
OR: switch on the ignition.
Turning on the “Coming home” light
●
Switch the ignition o.
The “Coming home” light comes on if the au-
tomatic headlight control is switched on
and the light sensor detects darkness.
The lights-o delay countdown starts when
the last door or rear lid of the vehicle is closed.
Turning o the “Coming home” light
●
It switches o automatically after the set
lights-o delay time has elapsed.
●
EITHER: it is automatically deactivated if, 30
seconds after the function has been activated,
any vehicle door or the rear lid is still open.