Anti-trap function of the sunshade blind
The anti-trap function can reduce the risk of
injury when closing the sunshade blind ››› .
If the blind encounters resistance or an obsta-
cle when closing, it will reopen immediately.
●
Check why the blind did not close.
●
Try to close the blind again.
●
If the blind still cannot be closed due to an
obstacle or resistance, it will reopen immedi-
ately. Once open, it can be closed for a short
space of time without the anti-trap function.
●
If it is still not possible to close the blind,
close it without the anti-trap function.
Closing the sunshade blind without the anti-
trap function
●
Try to close the blind again.
●
If it still cannot be closed, within 5 seconds
slide the function button backwards without
releasing it ›››Fig.101 until the blind closes
fully. The blind closes without the interven-
tion of the anti-trap function!
●
If it is still not possible to close the blind, visit
a specialised workshop.
If the function button is released during clos-
ing, the blind opens automatically.
The button reacts dierently than expected
Moisture, dirt, grease, etc., can limit the opera-
tion of the buttons. Make sure the buttons are
always clean and dry.
WARNING
Closing the sun blind without the anti-trap
function can cause serious injury.
●
Always close the blind with care.
●
Do not allow anyone to remain in the blind
travel area, particularly when closing without
the anti-trap function.
●
The anti-trap function does not prevent
ngers or other parts of the body from be-
coming trapped against the roof frame and
injuries occurring.
To Next Page
Loading...
