EasyManua.ls Logo

Cupra BORN 2024 - Page 204

Cupra BORN 2024
370 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
202
Parking and manoeuvring
Troubleshooting
The parking system behaves dierently than
expected
There can be several causes:
The system requirements are not met.
The sensors or the camera are dirty or have
ice on them ›››page333.
The camera lens is not clean and the camera
image is not clear ›››page333.
Some noise sources, such as a jackhammer
or a cobblestone surface can interfere with the
ultrasound signal.
The vehicle has some type of damage in the
sensor or camera area, e.g. due to a parking
impact.
The sensor detection zone or eld of view of
the camera are blocked by an accessory, e.g. a
bike rack.
Changes have been made to the paintwork
or structural modications in the sensor or
camera area, e.g. at the front of the vehicle or
to the running gear.
Also take into account the messages displayed
on the infotainment system display.
Sensor or camera without visibility, or the
parking system has been switched o
If a sensor fails, that sensor zone is perma-
nently switched o. The aected sensor zone
may be displayed on the infotainment system
with a
symbol and a greyed-out graphic
segment. If necessary, the parking system
switches o the aected zone.
If the park assist is not working properly, a
continuous audible signal sounds for a few
seconds when it is switched on. If applicable,
a message to this eect is displayed on the
instrument cluster display
Check if one of the causes indicated above
has occurred.
Once the source of the problem has been
eliminated, the system may be reconnected.
If the problem persists, consult a specialised
workshop.
Park Distance Control
Plus (Park Pilot)
Description
Fig.134 Parking aid view on the
Infotainment system display.
Parking aid plus assists the driver by giving
visual and audio warnings about obstacles de-
tected in front of and behind the vehicle.
The bumpers are tted with sensors. When
an obstacle is detected, it is indicated by au-
dible signals and in the Infotainment system
›››Fig.134.
When moving close to an obstacle, it is possi-
ble to know if the obstacle is in front of the
vehicle or behind it according to the sound
frequency.

Table of Contents

Related product manuals