Cupra BORN 2024 - Page 205

Parking and manoeuvring
203
Park Distance Control Plus (Park Pilot)
A
B
C
D
The approximate measurement range of the
sensors is:
1.20 m
0.90 m
1.60 m
0.90 m
As you approach the obstacle, the frequency
of the audible signals will increase. The signal
will sound continuously at around 0.30 m: Stop
the vehicle!
If the separation is maintained, the volume of
the warning starts to decrease after about 2.5
seconds and for the next 2.5 seconds it is fades
away until disappearing completely.
Error messages
If a an error or fault message is displayed on
the instrument cluster in Park Assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
next time the parking aid is connected.
If a rear sensor is faulty, only the obstacles in
the front area are detected. If a front sensor is
faulty, only the obstacles in the rear area are
displayed. The symbol is displayed.
We recommend taking the vehicle to a special-
ised workshop to have the fault repaired.
Parking assist settings
The indications and audible signals are set in
the Infotainment system: function button >
Assistants > Parking > > Settings.
●
Automatic activation: On/o
●
Front volume: Volume in the front and rear
area.
●
Rear volume: Volume in the rear area.
●
Reduce volume: When the parking aid is
switched on, the volume of the audio source
will be reduced, depending on the selected
option.
WARNING
●
Always pay attention, by looking directly,
to traic and the area around the vehicle.
Assistance systems are not a replacement for
driver awareness. Responsibility always lies
with the driver.
●
The sensors have blind spots in which ob-
stacles and people are not detected. Pay spe-
cial attention to children and animals.
●
Always keep visual control of the surround-
ings: use the mirrors for additional help.
NOTICE
Park assist plus functions can be
aected by
various factors which may cause damage:
●
Under certain circumstances, the system
does not detect or display certain objects:
–
Chains, trailer draw bars, bars, fences,
posts and thin trees.
–
Objects that are located above the sen-
sors, such as protrusions in a wall.
–
Objects with certain surfaces or struc-
tures, such as wire mesh fences or powder
snow.
●
Certain surfaces of objects and garments
do not reect the ultrasound sensors' signals.
The system cannot detect these objects or
people wearing such clothes correctly.
●
Sensor signals may be aected by external
sound sources. This may prevent them from
detecting people or objects.
●
If the system warns you of the proximity of
a low obstacle, please note that after being
detected by the system, the obstacle in ques-
tion may disappear from the measurement
sensors as the vehicle moves closer, and the
system will no longer warn of its presence. In
certain circumstances, objects such as high
kerbs that could damage the underside of
the vehicle are not detected.
●
If the parking distance warning system is
ignored, the vehicle could suer considera-
ble damage.