Cupra BORN 2024 - Automatic Activation

204
Parking and manoeuvring
●
Damage to the radiator grille, bumper,
wheel arch and vehicle underbody can mod-
ify the orientation of the sensors. This can
aect the parking aid function.
Have the function checked by a specialised
workshop.
●
A number plate or number plate holder
with dimensions that exceed the space for
the number plate, or a cured or deformed
number plate can cause false detections or a
loss of visibility for the sensors.
Note
●
The display on the Infotainment system
screen shows a slight time delay.
●
In certain situations, the system can give a
warning even though there is no obstacle in
the detected area:
–
Rough or cobbled surfaces or surfaces
with long grass.
–
External ultrasound sources, such as
other vehicles equipped with ultrasound
systems.
–
Heavy rain or snow, hail or dense exhaust
gases.
–
If the number plate is not properly se-
cured to the surface of the bumper.
–
Gradient changes.
●
In order to guarantee good operation, keep
the sensors clean, free of snow and ice, and
do not cover them with stickers or other ob-
jects.
●
If you use high-pressure or vapour equip-
ment for cleaning, do not apply it directly,
unless you do so very briey, and always keep
a distance of more than 10 cm away.
●
Fitting certain accessories to the front of
the vehicle, such as a plate holder with ad-
vertising, may interfere with the operation of
the Park Assist.
●
We recommend that you practice parking
in an area without traic.
●
The volume and tone of the signals and
indications can be changed.
Operating Park Assist Plus
Switching on and o manually
●
Press button in the infotainment system
( > Assistants > Parking assist > Parking
aid).
Automatic activation
●
Select reverse gear.
●
OR: if you drive forward at a speed of less
than 15 km/h (9 mph) and you encounter an
obstacle, it is detected when it is optically ap-
prox. less than 95 cm. away, or acoustically ap-
prox. 50 cm. away. If the automatic connection
is activated, a reduced display is shown.
●
OR:
if the vehicle moves back a certain dis-
tance (between approx. 10 and 20 cm approx
depending on whether or not an obstacle is
detected).
When the Plus Parking Aid connects auto-
matically, a diagram of the vehicle and the seg-
ments will appear on screen. This function will
be available unless the user has deactivated it.
It only operates every time the speed drops
below 15 km/h (9 mph) for the rst time.
Automatic activation of park assist can be
switched on and o in the infotainment sys-
tem:
●
Switch the ignition on.
●
In the infotainment system select > Assis-
tants > Parking > Parking aid.
●
Check the Automatic activation box.
If activated automatically, an audible sound
warning will only be given when obstacles in
front are at a distance of less than 50 cm. ap-
prox.
If it is switched o using the button in the
infotainment system, one of the following ac-
tions must be taken for it to reactivate auto-
matically:
●
Switch o the ignition and switch it on again.
●
EITHER: drive forward at over approx.
15km/h (9mph).
●
OR: switch the automatic activation on and
o in the Infotainment system.