Cupra BORN 2024 - Troubleshooting

Parking and manoeuvring
221
Peripheral view system (Top View Camera)
1
2
3
4
Go to the selected parking space
Centre the vehicle inside the parking
space
Road
Parking space
Side boundary of the parking space
Rear boundary of the parking space
Parking
●
In the infotainment system select > Driver
assist > Park assist before passing in front of
the selected parking space.
●
With reverse assist connected and in opera-
tion, press the function button .
●
Stop the vehicle in front of the parking space
›››Fig.145
2
.
●
Reverse while turning the steering wheel so
that the yellow lines enter the parking space.
The green and yellow lines must match the
side boundary lines
3
.
●
Stop the vehicle when the red line has
reached the rear boundary
4
.
Troubleshooting
The system behaves dierently than expec-
ted
There can be several causes:
●
The camera is dirty
›››page333. In addi-
tion to dirt and snow, camera visibility can be
reduced by detergent residue or any type of
coating.
●
The system requirements must be met
›››page219.
●
The camera is covered with water.
●
The vehicle has some type of damage in the
camera area, e.g. due to a parking impact.
●
The eld of view of the camera is blocked by
an accessory, e.g. a bicycle carrier system.
●
Changes have been made to the paint in the
camera area, or structural modications have
been made to a component such as the run-
ning gear.
Camera with no visibility, fault message, the
system disconnects
●
Clean the camera or remove any stickers or
accessories from it ›››page333.
●
Check for visible damage.
Possible solution
●
Temporarily disconnect the system.
●
Check if one of the causes indicated above
has occurred.
●
Once the source of the problem has been
eliminated, the system may be reconnected.
●
If the system still behaves unpredictably,
have it checked by a specialised workshop.
Peripheral view system
(Top View Camera)
Introduction
Using 4 cameras, the system generates a rep-
resentation that is shown on the infotainment
system display. The cameras are located on the
radiator grille, the exterior mirrors and the rear
lid.
The functions and representations of the Area
View system may vary depending on whether
or not the vehicle has ParkPilot.
WARNING
The image from the cameras does not make
it possible to calculate the distance to the
obstacles (people, vehicles, etc.) precisely,
so using them could cause serious accidents
and injury.
●
The camera lenses augment and distort the
visual eld and the objects on the screen are
seen dierently and imprecisely.
●
Certain objects may not be shown or may
not be shown very clearly, for example, posts
or thin rails, due to the screen resolution or if
light conditions are insuicient.
●
The cameras have blind spots in which ob-
stacles and people are not registered.