Cupra BORN 2024 - Page 24

22
Driver information
The drowsiness monitor informs the driver
whether his or her driving behaviour is indi-
cative of fatigue.
The drowsiness monitor determines the driv-
er's driving behaviour and uses this information
to assess driver fatigue. If the system detects
that the driver is tired, it indicates this visually
on the instrument cluster display by means of
a control or warning lamp in combination with
a supplementary text message. It also issues
an audible warning ›››page23. The text
message on the instrument cluster display is
displayed for 4 to 6 seconds.
Operating conditions
Driving behaviour is assessed only at speeds
above 65 km/h and thereafter only at speeds
above 60 km/h.
WARNING
The drowsiness monitor is no substitute for
the driver's attention and only works within
the limits of the system. Therefore, the
drowsiness monitor may not detect that the
driver is tired in all situations and may not
give a warning or may give a delayed or unin-
tended warning. There is a risk of accidents
and serious or even fatal injuries.
●
Always pay proper attention and do not rely
solely on the system. The driver is responsi-
ble for his or her tness to drive at all times.
●
Note the limits of the system
›››page22.
●
Never drive a vehicle when you are tired.
●
During long journeys, take regular and suf-
cient breaks.
●
Follow the information on the instrument
cluster display and respond as prompted.
›››page23.
System limits aecting the drowsi-
ness monitor
The drowsiness monitor has system-related
limitations. The following conditions may limit
the drowsiness monitor's operation, or prevent
it from operating at all:
●
Speeds below 60 km/h.
●
Speeds over 130 km/h.
●
Roads with many curves.
●
Roads in poor condition.
●
Adverse weather conditions.
●
Roadworks.
●
Sporty driving style.
●
Towing a heavy or very long trailer.
●
The driver is distracted.
Note
The drowsiness monitor has been developed
for use only when driving on motorways and
main roads in good condition.
Microsleep
No urgent warning is issued in case of micro-
sleep.
Restarting the drowsiness monitor
The drowsiness monitor restarts in the follow-
ing situations:
●
If the ignition is switched o.
●
The driver's seat belt is unbuckled and the
driver's door is open.
●
The vehicle has been stopped for more than
30 minutes.
Driving with the drowsiness moni-
tor
Connection and disconnection
Depending on the country, the drowsiness
monitor is activated whenever the vehicle's
drive system is activated. In this case, the info-
tainment system displays an overview of the
individual systems and automatically activated
functions in the input menu.
If desired, you can switch o the drowsiness
monitor manually in the infotainment system:
1. Open the Assistance systems menu.
2.
Switch the drowsiness monitor on or
o in the corresponding submenu
›››page33..