Cupra BORN 2024 - Page 28

26
Driver information
1)
Not available in all markets.
●
If the problem persists, visit a duly qualied
workshop. CUPRA recommends that you visit
an oicial dealer.
Road signs detection sys-
tem
Introduction
1)
The dynamic road sign display system records
standard traic signs by means of a camera
located in the upper central area of the wind-
screen, housed in the compartment at the
base of the interior mirror, and reports any
speed restrictions, overtaking prohibitions and
warning signs that it recognises.
Within its limitations, the system also displays
a additional sign to indicate aspects such as
temporary prohibitions. Even on routes with-
out signs, the system can, if necessary, display
the applicable speed limits.
Road sign recognition does not work in all
countries. Keep this in mind when travelling
abroad.
The additional signs are displayed on the
Head-up-Display and on the instrument clus-
ter as generic additional signs.
Shown on the display
Fig.7 On the instrument cluster display:
example of speed limits with a generic
additional sign.
In Germany, on motorways and normal roads
for vehicles, besides speed limits and overtak-
ing provisions the system also displays end of
restriction signs. In all other countries the cur-
rently valid speed limit is displayed instead.
The road signs detected by the system are
displayed on the instrument cluster display
›››Fig.7 and, depending on the navigation
system tted in the vehicle, in the infotainment
system as well .
Depending on the equipment, an indication is
also displayed on the Head-up-Display.
Display of road signs
After checking and evaluating the information
from the camera, the infotainment system and
actual vehicle data, the system displays up to
two current road signs, and a generic addi-
tional sign ›››Fig.7:
●
First: The sign that is currently valid for the
driver is displayed on the left hand side of the
screen, e.g. a prohibition of driving at over
130km/h (80mph).
●
Second: Another road sign, such as a warn-
ing sign, can be displayed in second place.
●
Additional sign: If an additional sign is de-
tected, e.g. for temporary limits, it is shown be-
low the valid road sign. For system reasons, a
generic sign is displayed instead of the actual
detected sign.
The valid road sign is displayed on the Head-
up-Display by the generic additional sign.
The warning sign display is not available in all
countries and the system may not be able to
detect all existing warning signs.
No entry sign
The road sign recognition system gives a warn-
ing on the instrument cluster when a no entry
sign is passed on a one-way road or an en-
trance to a motorway or highway.