Cupra BORN 2024 - Check after 10 Minutes of Driving

328
Wheels and tyres
●
If it is not possible to inate the tyre to at
least 2.0bars (29psi / 200kPa), the tyre is
too badly damaged. The sealant is not in a
good condition to seal the tyre. Do not con-
tinue driving. Seek specialist assistance.
NOTICE
Switch o the air compressor after a maxi-
mum of 8 minutes of operation to avoid over-
heating! Before switching on the air com-
pressor again, let it cool for several minutes.
Check after 10 minutes of driving
Screw in the inator tube ›››Fig.199
8
again
and check the pressure on the gauge
7
.
1.3bar (19psi / 130kPa) or lower:
●
Stop the vehicle! The tyre cannot be sealed
suiciently with the tyre mobility set.
●
You should obtain professional assistance
››› .
1.4 bar (20 psi/140 kPa) and higher:
●
Set the tyre pressure to the correct value
again.
●
Carefully resume your journey until you
reach the nearest specialised workshop with-
out exceeding 80km/h (50mph).
●
Have the damaged tyre replaced.
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious injury.
●
Do not continue driving if the tyre pressure
is 1.3bar (19psi / 130kPa) or lower.
●
Seek specialist assistance.