Cupra BORN 2024 - Page 65

Safety
63
Transporting children safely
Fig.42 Front passenger seat: adjustment
and assembly according to the Top Tether
belt.
Fig.43 Front passenger seat: adjustment
and assembly according to the Top Tether
belt.
●
Deploy the Top Tether belt according to the
child seat manufacturer’s instructions.
●
Position the belt under the headrest (ac-
cording to the instructions of the seat itself, lift
or remove the headrest if necessary).
For vehicles with integrated headrests, pass the
Top Tether belt over the headrest or through
the headrest recess as shown in the image
›››Fig.42, ›››Fig.43.
●
Slide the belt and secure it properly with the
anchor on the rear seat backrest ›››Fig.39 ,
›››Fig.40.
●
Tighten the belt securely according to the
manufacturer’s instructions.
Release the tether belt
●
Loosen the belt according to the manufac-
turer’s instructions.
●
Press the lock and release it from the anchor
bracket.
WARNING
Installing safety seats incorrectly will increase
the risk of injury in the event of a collision.
●
Never attach the tether belt to a fastening
hook in the luggage compartment.
●
Never attach or secure luggage or other
items to the lower anchor points (ISOFIX) or
Top Tether anchor points.
WARNING
Child restraint anchors are designed to sup-
port the loads of properly adjusted child
restraint systems. Under no circumstances
should they be used to attach adult seat
belts, harnesses or other items or equipment
to the vehicle.
Fitting a child seat using the seat
belt
If you want to t a universal approval category
(U) child seat in your vehicle, you must check
that the seat is approved for your vehicle.
You will nd any necessary information on the
child seat’s orange ECE approval label.
The following table shows the dierent tting
options.