Cupra BORN 2024 - Page 78

76
High-voltage battery
1
2
Indicators ›››Fig.53
In the vehicle
At the charging station
Indicators ›››Fig.54
Voltage up to 500 volts
Voltage of up to 1000 volts.
The indicators are located on the vehicle's
charging socket, on components of the lo-
cal charging infrastructure (charging station,
socket) and on the charging cable. The indi-
cators refer to charging connection standards
according to IEC 62196.
WARNING
Charging the vehicle at unveried electrical
installations can cause serious injury and
damage.
●
If there is no indicator or if the charging in-
frastructure is unknown, an electrical instal-
lation expert should be consulted rst.
Charging with alternating current
(AC)
Fig.55 Opening the charging socket
cover.
Fig.56 Behind the battery charging cover
on the rear right-hand side: Charging
socket
›››Fig.56
Charging process display
Charging socket
The battery charger installed in the vehicle
converts alternating current from the public
supply into direct current.
AC charging station or socket cable: The vehi-
cle’s high-voltage battery can be charged us-
ing alternating current (AC) through the corre-
sponding charging socket
2
.
Connecting the charging cable
●
Firstly, connect the charging cable to the
socket, or public or home charging station.
Next, fully unwind it.
●
Charging cable for domestic power sockets:
The protection device performs a self-test
›››page90.
●
If the vehicle is unlocked, the battery charg-
ing cover opens when the indicated zone is
pressed ›››Fig.55.
●
Plug the charging connector into the charg-
ing socket. Check that the charging connector
is fully plugged in.
The connector locks automatically.
The LED (charging process indicator) of the
charging socket
1
ashes or ashes white
›››Fig.56 , ›››page78.
You can set the charging as required in the
infotainment system ›››page83.