EasyManua.ls Logo

Cupra FORMENTOR 2024 - Page 112

Cupra FORMENTOR 2024
424 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
110
Opening and closing
Opening the rear lid
Unlock the vehicle and briey press the han-
dle of the rear lid. On vehicles with Keyless Ac-
cess you can directly press the handle of the
rear lid. The rear lid is unlocked if an authorised
key is recognised in the proximity of the vehi-
cle.
EITHER: pull the button on the driver
door upwards for approx. 1 second ›››Fig.83.
The button also works when the ignition is
switched o.
OR: press and hold the button of the vehi-
cle key for approx. 1 second. If the vehicle is
locked, only the rear lid is unlocked (the doors
remain locked).
OR: on vehicles with Keyless Access and
sensor-controlled opening you can open the
rear lid by moving one foot in the area of the
sensors located below the rear bumper (Easy
Open ›››page111). The rear lid will open
automatically.
Closing the rear lid
Briey press the button on the rear
lid ›››Fig.82, ››› in Introduction on
page108.
OR: pull up and hold the button on the
driver’s door until the rear lid is fully closed
›››Fig.83 (only with the ignition switched on).
EITHER: press and hold the button of the
vehicle key until the rear lid closes.
OR:
on vehicles with Keyless Access and sen-
sor-controlled opening, move a foot in the
area of the sensors located below the rear
bumper (Easy Open ›››page111). The vehi-
cle key must be in the Keyless Access system
detection zone at the rear outside the vehicle.
OR: hold the rear lid by one of the handles
tted to the inner lining and close it by moving
it downwards.
The rear lid lowers automatically to the nal
position and also locks automatically ›››
in
Introduction on page108.
Interrupting opening or closing
After beginning to open or close the rear lid,
the action can be halted by pressing one of the
buttons.
If you press one of the buttons again, the
rear lid will move again in the original direction.
If the rear lid meets with resistance or an ob-
stacle during the automatic opening or closing,
opening or closing will be interrupted imme-
diately. For the closing process, the rear lid
opens again slightly.
Check why it has not been possible to open
or close the rear lid.
Try to open or close the rear lid again.
If necessary, the rear lid can be opened or
closed by hand using reasonable force.
Particular features if towing a trailer
If the factory-tted towing bracket is electri-
cally connected to a trailer ›››page309, the
electric rear lid can only be opened or closed
with the buttons on the rear lid itself.
Audible warnings
Throughout the process of opening or clos-
ing the rear lid, acoustic warnings can be
heard. Exception: when the rear lid is opened
manually using the handle or the Easy Open
function with the movement of the foot or
closed using the button on the rear lid itself
›››Fig.82.
Modifying and memorising the opening an-
gle
If the space behind or above the vehicle is less
than the travel area of the rear lid, you can
change the opening angle of the rear lid.
To memorise a new opening angle, the rear lid
must be open at least halfway.
Interrupt the opening process in the desired
position.
Press the button ›››Fig.82 on the rear lid
for at least 3 seconds.
The opening angle is memorised. Memorisa-
tion is indicated by blinking of the hazard warn-
ing lights and an audible warning.

Table of Contents

Related product manuals