EasyManua.ls Logo

Cupra FORMENTOR 2024 - Operating the Sunroof

Cupra FORMENTOR 2024
424 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
116
Opening and closing
After switching o, it is still possible to
open or close the sunroof during a short
space of time provided that neither the
driver nor passenger door is opened.
NOTICE
To prevent damage, during winter temper-
atures remove any ice or snow that might be
on the car roof before opening the sunroof
or adjusting the tilt position.
Before leaving the vehicle or in case of
rainfall, always close the sunroof. With the
sunroof open or in a tilted position, water can
enter the interior and can cause considera-
ble damage to the electrical system. As a re-
sult, other damage can occur in the vehicle.
Note
Leaves and other loose objects that accu-
mulate on the sunroof rails should be regu-
larly cleaned away either by hand or with a
vacuum.
If the sunroof does not work correctly, the
anti-trap function will not work either. Con-
tact a specialised workshop.
Operating the sunroof
Fig.88 On the headliner: glass roof
button.
The functional area can be operated in two
ways: by sliding and pressing.
Sliding: The roof is opened or closed totally
or partially.
Pressing: The roof is raised, opened or
closed totally or partially. Press again to stop
the automatic movement.
Raising, opening and closing the sunroof
Opening the sunroof:
Automatic movement: slide your nger back
over the functional area ›››Fig.88
A
.
Manual movement: slide back over the func-
tional area and hold it there.
Closing the sunroof:
Automatic movement: slide your nger for-
ward over the functional area
A
.
Manual movement: slide forward over the
functional area and hold it there.
Raise the sunroof (it is only possible to raise the
sunroof if it is closed):
Automatic movement: press briey in the
centre of the functional area
B
Closing the sunroof when raised:
Automatic movement: slide your nger for-
ward over the functional area
A
.
Or press briey in the centre of the func-
tional area
B
.
Stop the automatic opening or closing move-
ment:
Press the functional area again
A
.

Table of Contents

Related product manuals