Cupra FORMENTOR 2024 - Removing and Fitting the Headrests

Seats and head restraints
125
Headrest
Adjusting the height of the head restraints
●
Grab the sides of the head restraints with
both hands and push upwards to the desired
position. To lower it, repeat the same action,
pressing the button on the side
1
›››Fig.98 ,
›››Fig.99.
●
The headrest must lock correctly in one po-
sition.
Removing and tting the headrests
Fig.100 Front head restraint: removal.
Fig.101 Rear head restraint: removal.
Removing the front head restraints
●
Lower the head restraint if necessary.
●
To unlock it, look for the rabbet on the bot-
tom of the backrest and press in the direction
of the arrow ›››Fig.100
1
.
●
Remove the head restraint in the direction of
the arrow
2
.
Fitting the front head restraints
●
Place the head restraint in the correct posi-
tion on the guides of the corresponding back-
rest and insert it.
●
Press the head restraint downwards until the
bars lock.
●
Adjust the head restraint according to the in-
structions on the correct position of the seat.
Removing the rear head restraints
To remove the head restraint, the correspond-
ing backrest must be partially folded forward.
●
Unlock the backrest ›››page122.
●
Move the head restraint upwards until it ar-
rives to the top.
●
Press button ›››Fig.101
1
, while simulta-
neously pressing on the safety hole
2
with a
at screwdriver a maximum of 5 mm wide, and
remove the headrest.
●
Move the backrest until it engages properly
››› in Folding down and raising the rear
seat backrest on page123.
Fitting the rear head restraints
To mount the external head restraints, the cor-
responding backrest must be partially folded
forward.
●
Unlock the backrest ›››page122.
●
Insert the head restraint bars into the guides
until they perceptibly engage. It should not be
possible to remove the head restraint from the
backrest.
●
Move the backrest until it engages properly
››› in Folding down and raising the rear
seat backrest on page123.