Cupra FORMENTOR 2024 - Page 131

Lights
129
Vehicle lighting
Automatic dipped beam headlight control
When the automatic dipped beam is switched
on, the vehicle's lighting and the lighting of the
instruments and controls turn on and o under
the following conditions:
●
The light sensor has detected darkness.
●
The wiper has been on for some time.
When the lights are on, the control lamp lights
up in green.
The automatic dipped beam is only an auxili-
ary function and cannot always identify all sit-
uations that may arise during driving with sui-
cient precision.
If the vehicle has the appropriate equipment,
the vehicle settings menu of the infotainment
system can be used to set the moment that
the dipped beam automatically switches on
›››page39.
Cornering light function
The cornering light is an additional function
to the dipped beam to improve lighting of the
side of the road when cornering at low speeds.
When the dipped beam is on, a static corner-
ing light comes on when driving at speeds be-
low about 40km/h (25mph) or on very tight
bends.
●
If the steering wheel is turned or the turn sig-
nal is switched on, the front fog light gradually
turns on. Once the turn has been made, the
cornering light progressively turns o.
●
When engaging reverse gear, both front fog
lights turn on.
Daytime running lights
Daytime running lights can increase the ve-
hicle’s visibility when driving in daylight and
they turn on automatically when the ignition
is switched on (if brightness is detected).
Motorway light
The motorway light is available on vehicles t-
ted with LED High lights.
The function is connected and disconnected
via the corresponding Infotainment system
menu.
●
Activation: when going above 110km/h
(68mph) for more than 10 seconds, the dip-
ped beam raises slightly to increase the driver's
visibility distance.
●
Deactivation: when reducing the speed of
the vehicle below 100km/h (62mph), the dip-
ped beam immediately returns to its normal
position.
Warning buzzers to warn that the lights have
not been switched o
If the ignition is not connected and the driver
door is open, an audible warning signal is heard
in the following cases: this will remind you to
turn the light o.
●
When the parking light is on ›››page130.
●
When the lamp or is on.
If the exit lighting is switched on (“Coming
Home” function), when you leave the vehicle
there will be no audio warning to warn you that
the lights are still on.
WARNING
Accidents can occur if the road is not well lit
and other users of the road cannot see the
vehicle or see it with diiculty.
●
The automatic dipped beam control ( )
only switches on the dipped beam when
there are no changes in brightness, and not,
for example when it is foggy.