Cupra FORMENTOR 2024 - Page 134

132
Lights
Turn on the main beam assistant or ad-
vanced main beam assistant (LED matrix)
●
Switch on the ignition and select mode
on the headlight control ›››Fig.105.
●
From the base position, press the turn sig-
nal and main beam headlights lever forwards
›››Fig.106
3
.
When the main beam assist is switched on,
the control lamp
on the instrument cluster
screen turns on. When the main beam is on,
the blue main beam control lamp on the
instrument cluster switches on.
Switching o the main beam assistant or ad-
vanced main beam assistant (LED Matrix)
●
Switching o mode on the headlight
control ›››Fig.105.
●
EITHER: if main beam assist is on, pull the
turn signal light and main beam headlights
lever back ›››Fig.106
4
.
●
OR: if the main beam assistant is on, but the
main beam does not turn on, press the turn
signal and main beam lever forwards to turn
the main beam on manually. Pull the turn sig-
nal and main beam lever back to switch o the
main beam manually, if necessary.
●
OR: switch o the ignition.
System limitations
In the following cases, the main beam head-
light must be switched o manually because
the main beam assist will not disconnect it on
time or disconnect it at all:
●
On insuiciently lit roads with highly reec-
tive signs.
●
If road users are insuiciently lit up, e.g. pe-
destrians or cyclists.
●
On closed curves, when the traic in the
opposite direction is partially hidden, on pro-
nounced slopes or inclinations.
●
On roads with traic in the opposite direction
and with a central reservation barrier where
the driver can see over it e.g. lorry drivers.
●
In case of fog, snow or heavy rainfall.
●
In case of swirling dust or sand.
●
If the windscreen is damaged in the camera's
eld of vision.
●
If the camera's eld of vision is misted up,
dirty or covered by a sticker, snow or ice.
●
If the camera is damaged or if the power
supply has been cut o.
WARNING
The comfort features of the main beam assist
must not lead you to take any risks. The sys-
tem is not a replacement for driver concen-
tration.
●
You must always control the main beam
yourself and adapt it to the light, visibility and
traic conditions.
●
The main beam regulator may not recog-
nise all driving situations correctly and may
operate with limitations in certain circum-
stances.
●
When the camera’s eld of view is dirty,
covered or damaged, the operation of the
main beam regulator may be aected. This
also applies when the vehicle’s lighting in-
stallation is modied, e.g. when additional
headlamps are installed.
NOTICE
To avoid aecting the operation of the sys-
tem, take the following points into considera-
tion:
●
Clean the eld of vision of the camera reg-
ularly and make sure it is free of snow and ice.
●
Do not cover the eld of vision of the cam-
era.
●
Check that the windscreen is not damaged
in the area of the camera’s eld of view.