Cupra FORMENTOR 2024 - Page 160

158
Air conditioning
●
Press the immediate on icon in the Info-
tainment system (while the vehicle is switched
o). During immediate air conditioning, the
vehicle reaches the set temperature in a maxi-
mum of 30 minutes.
●
Press the immediate on/o button in the My
CUPRA App.
●
Automatically by scheduling a departure
time in the My CUPRA App or in the infotain-
ment system in the Stationary air condition-
ing ›››page158menu.
Switching o the stationary air conditioning
In can be switched o in the following ways:
●
Press the immediate on/o button in the My
CUPRA App.
●
Press the immediate on/o icon in the
infotainment system (while the vehicle is
switched o).
●
Press the air conditioning o button in the
Air conditioning menu of the infotainment
system (while the vehicle is o).
●
Automatically, a few minutes after the
scheduled departure time.
●
Automatically if the charge level of the vehi-
cle's high-voltage battery drops excessively.
Note
●
Noises will be heard while the stationary air
conditioning is running.
●
When the outside humidity is high and the
ambient temperature is low, condensation
from the air conditioning system may evapo-
rate when the stationary air conditioning is
running. In this case, steam may come out
from under the vehicle. This does not mean
that there is an fault in the vehicle.
Programming the stationary air
conditioning
✓ Valid for: hybrid vehicles.
The stationary air conditioning can be pro-
grammed in the Infotainment system for a
scheduled departure time. You can set the de-
sired temperature of the vehicle interior for the
vehicle’s planned departure time.
Based on the desired temperature, the vehicle
calculates the time that the stationary air con-
ditioning needs to be switched on to reach this
temperature by the departure time. The maxi-
mum pre-operation time of the stationary air
conditioning is approx. 30 minutes before the
departure time.
Air conditioning the vehicle for departure
●
Open the Stationary air conditioning menu.
●
Press Exit to open the timer menu.
●
Set the scheduled departure time.
●
Activate the timer using the checkbox.
The earliest scheduled departure time is dis-
played in the infotainment system’s departure
menu, and can be switched on and o there
›››page41.
The stationary air conditioning switches o
automatically
●
After approx. 30 minutes if the vehicle is
air-conditioned by immediate air-conditioning
while the ignition is switched o.
●
After approx. 15 minutes if the drive system
has not been switched on by one hour after
the scheduled departure time.
●
When the state of charge of the high voltage
battery drops excessively.
Extended stationary air conditioning
If air conditioning for departure is to be used,
the electrical convenience consumers, such
as seat heating, steering wheel heating or the
heated rear window, can also be switched on
automatically before the departure time. The
electrical convenience consumers depend on
the equipment. They are only activated in low
temperature conditions.
To enable the use of these consumers:
●
Open the Stationary air conditioning
menu.
●
Tap Air conditioning.