Cupra FORMENTOR 2024 - Speed Limiter; Operating the Speed Limiter

200
Assistant systems
●
Front Assist has braked the vehicle.
●
If the fault continues, disconnect the Emer-
gency Assist and consult a specialised work-
shop.
Speed limiter
Introduction
The speed limited helps the driver not to ex-
ceed a set speed.
Speed range
The speed limiter helps avoid exceeding a pro-
grammed speed, from 30km/h (20mph) ap-
prox. and faster.
By selecting the speed limiter
The speed limitation can be interrupted at any
time by depressing the accelerator pedal fully,
beyond the point of resistance. As soon as the
saved speed is exceeded, the green indicator
light ashes and an audible warning signal may
sound. The speed is stored.
The limiter is reactivated automatically after re-
turning to less than the set speed.
Status display
When the speed limiter is switched on, the
instrument cluster display shows the saved
speed and the system status:
It lights up grey
The speed limiter is switched on but reg-
ulation is not active.
Lights up green
The speed limiter is switched on and ac-
tive.
Driving down slopes
Shift into a low gear before descending a long
hill. This makes use of engine braking and re-
lieves the brakes.
The vehicle cannot maintain the saved speed
in all driving situations. Always be ready to ap-
ply the vehicle’s brakes.
WARNING
After use, always switch o the speed limiter
to prevent the speed being regulated against
your wishes.
●
The speed limiter does not relieve the
driver of their responsibility to drive at the
appropriate speed. Do not drive at high
speed if not necessary.
●
Using the speed limiter under adverse
weather conditions is dangerous and can
cause serious accidents, e.g. aquaplaning,
snow, ice, leaves, etc. Only use the speed
limiter when the status of the road and the
weather conditions allow it.
Operating the speed limiter
Fig.135 On the multifunction steering
wheel: buttons to control the speed limiter.
Connecting
●
Press the button.
Then select “Speed limiter” from the driving
assistants menu.
Regulation has not yet taken place.
Start regulation
●
While driving, press the button .
The current speed is saved as a limit speed.
Adjusting the speed
The programmed speed can be set:
+ 1 km/h (1mph)
- 1 km/h (1mph)