Cupra FORMENTOR 2024 - Page 24

22
Driver information
1)
Not available in all countries.
–
–
–
–
–
–
–
–
–
Note
●
There are dierent instrument panels and
therefore the versions and instructions on
the display may vary. In the case of displays
without warning or information texts, faults
are indicated exclusively by the control warn-
ing lamps.
●
Some indications on the instrument panel
screen may be concealed by a sudden event,
e.g. an incoming call.
●
Depending on the equipment, some set-
tings and instructions can be carried out or
displayed on the infotainment system as well.
●
If there are several warnings at the same
time, the symbols will be displayed one after
the other for a few seconds. The symbols will
stay on until you remove the cause.
●
If when switching on the ignition warnings
are shown about existing faults, it might not
be possible to change the settings or show
the information as described. In this case,
go to a specialised workshop and request a
repair.
Driving data indicator
The driving data display shows a range of driv-
ing data and consumption values.
Change from one display to another
●
Turn the right thumbwheel of the multifunc-
tion steering wheel ›››page34.
Changing memory
●
Depending on the view, select Driving data
and press the left arrow or the button on the
multifunction steering wheel.
Since start: The memory is deleted if the
journey is interrupted for more than 2
hours.
Since refuel: Display and storage of the
journey data and the consumption values
collected. When refuelling, the memory is
deleted.
Long-term: This memory contains travel
data up to a maximum of 19hours and
59minutes or 99hours and 59minutes, or
up to a maximum of 1999.9 km or 9999.9
km. When one of these values is exceeded
(varies depending on the version of the
instrument panel), the memory is deleted.
Delete journey data presets
●
Select the memory that you wish to erase.
●
Keep the button on the multi-function
steering wheel pressed for approximately 2
seconds.
Select the instructions
On the instrument cluster, it is selected man-
ually using the button on the multifunction
steering wheel. To access the contents of the
tube, rotate the right hand thumbwheel up/
down.
Current consumption: The current fuel
consumption display operates throughout
the journey, in litres/100 km; and with the
engine running and the vehicle stopped, in
litres/hour.
Average consumption: The average fuel
consumption is displayed after driving for
approximately 300metres.
Travelling time: This indicates the hours
(h) and minutes (min) since the ignition
was switched on.
Range: Approximate distance in km that
can still be travelled if the same driving
style is maintained.
AdBlue range or
: Approximate dis-
tance in km that can still be travelled with
the current level of the AdBlue® tank with
the same driving style. The indication ap-
pears from a range of less than 2,400 km
and cannot be deactivated.
1)
Distance travelled: Distance covered in
km (m) after switching on the ignition.