Cupra FORMENTOR 2024 - Page 245

Parking and manoeuvring
243
Reverse Assist (Rear View Camera)
1
2
3
4
Assistance function for hitching a trailer
On vehicles with a factory-tted towing device,
this function can be used to move the vehicle
close to a tow bar.
Auxiliary lines are shown in the infotainment
system.
Green lines: distance to the trailer hitch. The
distance between the lines is approx. 0.30 m
Yellow line: pre-calculated direction of the
trailer hitch depending on how the steering
wheel is turned.
Cross traic
This view helps to monitor traic behind the
vehicle and can be used, for example, when
exiting garages or narrow exits.
Angle parking
Fig.162 Display on the infotainment
system screen: parking with the reverse
assistant.
Key to the ›››Fig.162:
Find a parking space
Go to the selected parking space
Centre the vehicle inside the parking
space
Road
Parking space
Side boundary of the parking space
Rear boundary of the parking space
Parking
●
In the infotainment system select > Driver
assist > Park assist before passing in front of
the selected parking space.
●
With reverse assist connected and in opera-
tion, press the function button .
●
Stop the vehicle in front of the parking space
›››Fig.162
2
.
●
Reverse while turning the steering wheel so
that the yellow lines enter the parking space.
The green and yellow lines must match the
side boundary lines
3
.
●
Stop the vehicle when the red line has
reached the rear boundary
4
.
Troubleshooting
The system behaves dierently than expec-
ted
There can be several causes:
●
The camera is dirty ›››page385. In addi-
tion to dirt and snow, camera visibility can be
reduced by detergent residue or any type of
coating.
●
The system requirements must be met
›››page241.
●
The camera is covered with water.
●
The factory-tted towing bracket must
not be electrically connected to a trailer
›››page309.