Cupra FORMENTOR 2024 - Page 248

246
Parking and manoeuvring
Trailer mode
The Area View system conceals, in the rear
camera area, all the auxiliary guiding lines
when the factory-tted towing bracket is con-
nected electrically to a trailer ›››page309.
Note
To become familiar with the system and
its functions, CUPRA recommends that you
practice handling the Area View system in an
area where there is not too much traic or in
a car park.
Connecting and disconnecting
Connecting
●
Select reverse gear.
●
OR: in the infotainment system select >
Assistants > Parking assistant > Park assist.
Switching o
●
Drive forward at a speed of at least 15 km/h
(9 mph).
●
OR: press the function button.
Views of the peripheral vision sys-
tem (modes)
The red lines are indicate a distance of approx.
40 cm away from the vehicle.
Aerial views (bird's eye view)
Main mode:
The vehicle and its immediate vicinity
seen from above are shown. Depending
on the equipment, the ParkPilot's path
may also be displayed.
Front camera views (front view)
Cross traic.
This visualization helps to monitor traic
to the left, front and right of the vehicle
and can be used, for example, when ex-
iting garages or narrow exits
Angle parking.
The area in front of the vehicle is shown.
Orientation lines are shown to give guid-
ance.
Side camera views (side view)
Right and left sides.
The areas located directly to the side of
the vehicle seen from above are repre-
sented in order to navigate possible ob-
stacles more precisely.
Rear camera views (rear view)
Angle parking.
The area behind the vehicle is shown.
Auxiliary lines are shown to give guid-
ance.
Trailer coupling assistance function.
On vehicles with a trailer coupling assis-
tance function, the function will provide
guidance to facilitate hitching the trailer.
Auxiliary lines are shown in the infotain-
ment system.
Green lines: distance to the trailer hitch.
The distance between the lines is approx.
0.30 m
Yellow line: pre-calculated direction of the
trailer hitch depending on how the steer-
ing wheel is turned.
Cross traic.
This visualization helps to monitor traic
to the left, front and right of the vehicle
and can be used, for example, when ex-
iting garages or narrow exits.
Trailer Assist
Introduction
Trailer assist helps the driver to reverse and
manoeuvre with a trailer.
By moving the rotary knob of the exterior mir-
rors, the trailer assist directs the trailer that is
hitched. The driver has to accelerate, change
gears and brake!