Cupra FORMENTOR 2024 - Page 295

Infotainment system
293
Navigation
Range based on the route
The range required for the selected route is
recalculated taking into account dierent fac-
tors such as topography and road type. There-
fore the range value will be adjusted instantly
when the selection is made and recalculated
en route according to any conditions that may
not be initially assessed (weather, traic, etc.)
until arrival at destination, where the standard
range will be displayed again.
Suggestions
The destination synopsis uses recorded data to
propose possible destinations.
Select the destination and start navigation:
1. Tap and then Suggestions.
2. Select the desired destination. The route
guidance starts automatically.
Quick start: for a quick start, press and hold
the desired destination for a few seconds.
Last destinations
Navigation saves the last destinations to make
them available for a route guidance.
Select the destination and start navigation:
1. Tap and then Recent destinations.
2.
Press the desired destination.
3.
Press Start.
Quick start: for a quick start, press and hold
the desired destination for a few seconds.
Favourite destinations
Save up to 20 destinations as favourites.
To save a destination as a favourite press in
the split screen when entering the destination.
Select the destination and start navigation:
1. Tap and then Favourites.
2. Press the desired destination.
3. Press Start.
Note
Enter the destination as accurately as possi-
ble. If you enter a destination incorrectly, the
route guidance will not be able to start or it
will guide you to an incorrect destination.
Start route guidance by selecting from the
map
The navigation map includes active areas at
many points that are suitable for entering the
destination. To do this, press the desired posi-
tion or place on the map. If there is map data at
this point, you can start a route guidance.
Whether it is possible to enter the destination
through the navigation map depends on the
state of the data and it is not possible for all
positions.
To start “oroad navigation”, press an empty
area without position data.
Start navigation:
1. Press .
2. Move the view on the map until the desired
position can be selected. The navigation
map can be used by means of additional
nger movements ›››page289.
3. Press the desired destination on the map.
4. A pop-up window will appear where you
can tap on the corresponding icon:
●
: favourite destination.
●
: new route.
●
Start: starts the route to the destination.
Oroad navigation
“Oroad navigation” calculates routes to se-
lected destination points using unknown data.
When a destination point is outside the known
roads or position data, navigation nds the
route to the next point of the known road and
completes the path to the next destination
point with a direct connection.
Start navigation:
1.
Move the view on the map until the desired
position can be selected. The navigation
map can be used by means of additional
nger movements ›››page289.
2.
Press on any point on the map without po-
sition data.
3. A pop-up window will appear where you
can tap on the corresponding icon: