Cupra FORMENTOR 2024 - Store the Rear Shelf; Variable Luggage Compartment Floor

304
Storing objects
Store the rear shelf
Fig.184 In the boot: covers for storing the
rear shelf.
Fig.185 In the boot: tting the rear shelf.
Depending on the equipment, once the lug-
gage compartment shelf has been removed, it
can be stored under the boot oor.
●
Remove the left and right covers
›››Fig.184.
●
Place the rear shelf in the corresponding
housing ›››Fig.185.
●
Put the left and right covers in their original
position.
Variable luggage compartment
oor
Fig.186 Variable luggage compartment
oor: raised position; lowered position.
Fig.187
Variable boot oor: tilted position.
Variable oor in high position
●
To move from the low position to the
high position, lift the oor using the handle
›››Fig.186
1
, and pull it back until the front
of the oor has fully passed the supports
2
.
●
Move the oor forward over the supports as
far as the rear seat backrest and then lower the
oor with the handle
1
.
Variable oor in low position
●
To move from the high position to the
low position, lift the oor using the handle
›››Fig.186
1
, and pull it back until the front
of the oor has fully passed the supports
2
.
●
Now let the front part fall to the oor and
slide the oor forwards as far as the rear seat
backrest; lower the oor at the same time with
the handle
1
.