Cupra FORMENTOR 2024 - Page 34

32
Driver information
Activation and deactivation of the speed
change warning tone
The speed change warning tone provides the
driver with audible information about a change
in the speed limits. If desired, you can manually
switch o the change tone.
In the infotainment system:
1. Open the Assistance systems menu.
2. Open the Speed Warning.
3. Activate or deactivate the change
tone under the corresponding option
›››page39.
Concealing fault messages via the multi-
function steering wheel
1.
Press the button on the multifunction
steering wheel.
Trailer mode
For vehicles with a factory-installed towbar and
a trailer with electrical connection to the vehi-
cle, the recognition of traic signs that may
apply to the vehicle when towing a trailer, for
example applicable speed limits and no over-
taking signs, can be activated or deactivated in
the vehicle settings menu in the infotainment
system.
In trailer mode, the recognition of valid speed
limits can be adjusted to suit the type of trailer
and country-specic legal requirements.
In the infotainment system:
1. Open the Assistance systems menu.
2. Open Trailer detection.
3. To adapt the warning threshold to the
trailer mode, tap on in the Overtaking
warning menu option.
Speed warning function warning
levels
If the system detects that the maximum per-
mitted speed has been exceeded, it will in-
dicate this visually on the instrument cluster
screen by ashing the speed limit detected by
the system and, depending on the congura-
tion, will also issue an audible warning. A warn-
ing is issued at two levels.
Fig.8 On the instrument cluster screen:
violation of the detected speed limit
(illustration).
Speed warning - Level 1
Speed limit violation detected. The speed limit
detected by the system ashes continuously
on the instrument cluster and, depending on
the equipment, on the front display ›››Fig.8.
Speed warning - Level 2
Progressive violation of the speed limit has
been detected.
An audio signal sounds. The speed limit de-
tected by the system ashes continuously on
the instrument cluster and, depending on the
equipment, on the front display ›››Fig.8.
Note
●
The second warning level is activated if the
speed remains above the limit.
●
The second warning level is cancelled again
when the driver actively reduces the speed.
Troubleshooting
 Advanced road sign recognition is
not available
An audio signal sounds. A yellow control lamp
appears on the instrument cluster screen in
combination with the central yellow lamp. A
text message is also shown on the instrument
cluster screen and in the vehicle status menu.