Cupra FORMENTOR 2024 - Wheel Bolt Caps; Anti-Theft Wheel Nuts

372
Wheels and tyres
WARNING
●
After tting the temporary spare wheel,
check the tyre pressures as soon as possible.
Failure to do so may cause an accident. The
tyre pressure is listed on the back of the left
front door frame ›››page366.
●
Do not drive at over 80km/h (50mph)
when the temporary spare wheel is tted on
the vehicle: risk of accident!
●
Never travel more than 200km using a
temporary spare wheel.
●
Avoid heavy acceleration, hard braking and
fast cornering: risk of accident!
●
Never use more than one temporary spare
wheel at the same time, risk of accident.
●
No other type of tyre (normal summer or
winter tyre) may be tted on the compact
temporary spare wheel rim.
●
If you are driving using the spare wheel,
the ACC system could automatically switch
o during the journey. Switch o the system
when starting o.
Wheel bolt caps
Fig.235 Wheel: wheel bolts with caps.
Removal
●
Fit the plastic clip (vehicle tools ›››Fig.204)
over the cap until it clicks into place
›››Fig.235.
●
Remove the cap with the plastic clip.
The caps protect the wheel bolts and should
be remounted after changing the tyre.
The anti-theft wheel locking bolt has a spe-
cial cap. This only ts on anti-theft locking
bolts and is not for use with standard wheel
bolts.
Anti-theft wheel nuts
Fig.236 Anti-theft wheel bolt with cap
and adapter.
Loosening the anti-theft wheel bolt
●
Remove the wheel trim or hub cap.
●
Insert the special adapter ›››Fig.236
1
(vehicle tools ›››page329) onto the anti-
theft wheel bolt and push it on as far as it will
go.
●
Insert the wheel brace (vehicle tools) onto
the adapter as far as it will go.
●
Remove the wheel bolt ›››page373.