Cupra FORMENTOR 2024 - Page 71

Safety
69
Transporting children safely
WARNING
Child restraint anchors are designed to sup-
port the loads of properly adjusted child
restraint systems. Under no circumstances
should they be used to attach adult seat
belts, harnesses or other items or equipment
to the vehicle.
Fitting a child seat using the seat
belt
If you want to t a universal approval category
(U) child seat in your vehicle, you must check
that the seat is approved for your vehicle.
You will nd any necessary information on the
child seat’s orange ECE approval label.
The following table shows the dierent tting
options.
Weight group
Front passenger seat
a)
Rear side seat
Rear central
seat
b)
Airbag enabled
c)
Airbag deactivated
c)
Group 0 up to 10kg X U U U
Group 0+ up to 13kg X U U U
Group I 9 to 18kg
Rear-facing X U U U
Forward-facing U X U U
Group II 15 to 25kg U X U U
Group III 22 to 36kg U X U U
X: Not compatible for the installation of seats install chairs in this conguration.
U: Suitable for universal restraint systems for use in this weight group.
a)
Compliance with current national legislation and the manufacturer's instructions is required when using or installing child seats.
b)
For semi-universal chairs where the securing system is the car safety belt and the support bracket, do not use them in the centre rear seat.
c)
Seats without height adjustment should be placed in their rearmost position. Seats with height adjustment should be placed in their rearmost and highest
position.