Practical tips
It lights up yellow
The AdBlue reserve is low.
Refill AdBlue within the next kilometres (or miles) that
are indicated
›››
page 316 . SEAT recommends con-
tacting a specialised workshop.
and
They light up yellow
There is a fault in the AdBlue system or unsuitable
AdBlue fluid has been used.
Contact a specialised workshop. Have the system
checked there.
Several warning and control lamps should
light up f
or a f
ew seconds when the ignition
is switched on, signalling that the function is
being verified. They will switch off after a few
seconds.
WARNING
Observe the safety warnings
›››
in Con-
trol and w
arning lamps on page 83.
Fill AdBlue®
Fig. 199
AdBlue tank cap.
Operations prior to refilling
P
ark the v
ehicle on a flat surface and turn off
the ignition. If the vehicle is on a slope or on
a curb, the level indicator may not detect the
refill properly.
If an AdBlue® warning message is shown on
the instrument cluster display, fill with at
least the minimum required amount (ap-
prox. 5 litres). Only after adding this amount
will the system detect that AdBlue® has been
added and you will be able to start the en-
gine again. The maximum amount that can
be refilled is 11 litres.
Fill with a refill bottle
Only use AdBlue® that complies with the
ISO 22241-1 standard. Only use original
containers.
●
Open the tank cover
›››
Fig. 199 .
●
Unscrew the tank cap by turning it in an an-
ti-clockwise direction.
●
Please observe the manufacturer's instruc-
tions, indicated on the refill bottle.
●
Check the expiry date.
●
Remove the cap of the refill bottle.
●
Insert the neck of the bottle in the tank fill-
er neck vertically and screw the bottle on by
hand, by turning it in a clockwise direction.
●
Press the refill bottle in the direction of the
filler neck and hold it in this position.
●
Wait until the contents of the refill bottle
have been poured into the AdBlue® tank. Do
not compress or break the bottle!
●
Turn the bottle in a counter-clockwise di-
rection and gently pull it upwards
›››
.
●
The AdBlue® tank is full when no more liq-
uid comes out of the bottle.
●
Screw on the tank cap in a clockwise direc-
tion until it is tightly clo
sed.
●
Clo
se the fuel tank flap.
Operations before driving
●
After refilling the tank, only switch on the
ignition.
●
Leave the ignition on for at least 30 sec-
onds for the system to detect the fluid load.
●
Make sure you wait for at least 30 seconds
before starting the engine!
316
To Next Page
Loading...
