Cupra FORMENTOR - Variable Luggage Compartment Floor

Operation
Variable luggage compartment floor
Fig. 113
Variable luggage compartment floor:

raised position;

lowered position.
Fig. 114 Variable luggage compartment floor: in-
clined position.
Variable floor in high position
●
To move from the low position to the high
po
sition, lift the floor using the handle
›
››
Fig. 113
1
, and pull it back until the front
of the floor has fully passed the supports
›
›
›
Fig. 113
2
.
●
Move the floor forward over the supports
as f
ar as the r
ear seat backrest and then low-
er the floor with the handle
1
.
V
ariable floor in lo
w position
●
To move from the high position to the low
position, lift the floor using the handle
›››
Fig. 113
1
, and pull it back until the front
of the floor has fully passed the supports
›
›
›
Fig. 113
2
.
●
Now let the front part fall to the floor and
slide the floor f
orw
ards as far as the rear seat
backrest; lower the floor at the same time
with the handle
1
.
Variable floor in the tilted position
When the v
ariable floor is tilt
ed you can ac-
cess the spare wheel or anti-puncture kit
area.
●
Lift the variable floor in the high position
using handle
›››
Fig. 113
1
, pull it up and
push it t
o
wards the backrest of the rear seats
until it folds along the hinge line and the
movable part of the floor is resting on itself.
●
Rest the floor on its housings
›››
Fig. 114
(arrows).
WARNING
●
Always secure objects, even when the
luggage compartment floor is properly lif-
ted.
●
Only objects that do not protrude more
than 2/3 the height of the floor may be car-
ried between the rear seat and the raised
luggage compartment floor.
●
Only objects that do not weigh than ap-
proximately 7.5 kg may be carried between
the rear seat and the raised luggage com-
partment floor.
CAUTION
●
The maximum weight that can be loaded
on the luggage compartment variable floor
in the top position is 100 kg.
●
Do not let the luggage compartment
floor fall when closing it. Always carefully
136