Cupra FORMENTOR - Indications on the Instrument Panel Display

Driving
Stopping inertia mode
●
Press the brake or the accelerator pedal.
T
o t
ake advantage of the engine's inertia
mode, simply remove your foot from the ac-
celerator.
Applying both the inertia mode (= pro-
longed section with less energy) and inertia
disconnection (= shorter section without
the need for fuel) facilitates improved fuel
consumption and emission balance.
With Drive Profile
›››
page 225 , the inertia
mode can be activated in the Comfort or In-
dividual profiles. If the engine is set to Eco in
the Individual profile, it activates when the
operating conditions are met, regardless of
how smoothly you remove your foot from
the accelerator.
WARNING
●
If the inertia mode has been switched on,
take into account, when approaching an
obstacle, that the vehicle will not deceler-
ate in the usual manner: risk of accident!
●
When using inertia mode while travelling
down hills, the vehicle can increase speed:
risk of accident!
●
If other users drive your vehicle, warn
them about inertia mode.
Note
●
The operation of the inertia mode in
combination with hybrid engines (MHEV
and PHEV) can cause the combustion en-
gine to switch off.
●
The inertia mode will be automatically
disconnected on gradients steeper than
15%.
Indications on the instrument panel
display
Clutch

Clutch overheating! Please stop!
●
The clut
ch has overheated and could be
damaged. Stop and wait for the gearbox to
cool with the engine idling and press the P
parking lock button. When the warning lamp
and the driver message turn off, go to a spe-
cialised workshop to get the fault repaired. If
they do not turn off, do not continue driving.
Seek specialist assistance.
Faults in the gearbox
 Gearbox: Fault! Stop the vehicle
and place the lever in the position
P.
●
There is a fault in the gearbox. Stop the ve-
hicle in a safe place and do not continue
driving. Seek specialist assistance.
 Gearbox: System fault! You may
continue driving.
●
Have the fault corrected by a specialised
workshop without delay.
 Gearbox: System fault! You can
continue driving with restrictions.
Reverse gear disabled
●
Take the vehicle to a specialised workshop
and have the fault repaired.
 Gearbox: System fault! You can
continue driving in D until switch-
ing off the engine
●
Park the vehicle in a safe place. Seek spe-
cialist assistance.
 Gearbox: too hot. Adapt your
driving accordingly
●
Continue driving at moderate speeds.
When the warning lamp switches off, you
can continue driving in a normal manner.
 Gearbox: press the brake and en-
gage a gear again.
●
If the warning was caused by the tempera-
ture of the gearbox, this driver message will
be displayed when the gearbox has cooled
again.
222