Cupra FORMENTOR - Fitting a Child Seat Using the Seat Belt

Safety
Fitting a child seat using the seat belt
Fig. 31 On the rear seats: installing the child seat.
If you want to fit a universal approval catego-
ry (U) child seat in y
our vehicle, you must
check that the seat is approved for your ve-
hicle. You will find any necessary information
on the child seat’s orange ECE approval la-
bel. The following table shows the different
fitting options.
Weight group
Front passenger seat
a)
Rear side seat Rear central seat
b)
Airbag enabled airbag disabled
c)
Group 0 to 10 kg X U U U
Group 0+ to 13 kg X U U U
Group I 9 to 18 kg X U U U
Group II 15 to 25 kg X UF UF UF
Group III 22 to 36 kg X UF UF UF
X: Not compatible for the installation of seats install chairs in this configuration.
U: Suitable for universal restraint systems for use in this weight group.
UF: Acceptable for front-facing universal-category child restraint systems approved for this mass group.
a)
Compliance with current national legislation and the manufacturer's instructions is required when using or installing child seats.
b)
For semi-universal chairs where the securing system is the car safety belt and the support bracket, do not use them in the centre rear seat.
c)
Seats without height adjustment should be placed in their r
e
armost position. Seats with height adjustment should be placed in their rearmost and highest position.
40