Cupra TERRAMAR 2024 - Seat Functions; Memory Function; Memory Buttons

Seats and head restraints
127
Seat functions
1)
Not available in all markets.
●
Unlock the backrest ›››page124.
●
Insert the head restraint bars into the guides
until they perceptibly engage. It should not be
possible to remove the head restraint from the
backrest.
●
Move the backrest until it engages properly.
WARNING
Remove the rear headrests only when it is
necessary to t a child seat. After removing a
child seat, ret the headrest immediately.
Seat functions
Memory function
Fig.98 On the outer side of the driver's
seat: memory buttons.
Memory buttons
The memory buttons can be used to save and
activate settings for the driver seat and exterior
mirrors.
The settings will also be saved in the user of
the online services
1)
.
Save the settings for the driver seat and ex-
terior mirrors for forward gear
●
Apply the electronic parking brake.
●
Set the gearbox to the neutral position.
●
Switch the ignition on.
●
Adjust the driver seat and exterior mirrors.
●
Press for longer than 1 second ›››Fig.98.
●
Press the memory button in which to store
the settings within approx. 10 seconds. An
audible signal conrms that they have been
saved.
Save the settings of the front passenger ex-
terior mirrors for reversing.
●
Apply the electronic parking brake.
●
Set the gearbox to the neutral position.
●
Switch the ignition on.
●
Press whichever memory button you want.
●
Select reverse gear.
●
Adjust the front passenger exterior mirror so
that you can see, for example, the kerb edge
well.
●
The set position for the mirrors is automati-
cally saved and assigned to the key with which
you unlocked the vehicle.
Activating the settings
●
With the vehicle stopped and the ignition
switched on, press and hold the correspond-
ing memory button until the saved position is
reached.
●
OR: With the ignition switched o and the
driver's door open, briey press the corre-
sponding button.
The front passenger side exterior mirror auto-
matically changes from the position stored for
reversing as soon as the vehicle moves forward
at a speed of at least 15km/h (10mph) or
when the gear selection lever is changed to a
position other than R ›››page141.
Initialising the seat position memory
If, for example, the driver seat has been re-
placed, the position memory system must be
restarted.
Restarting deletes all memories and assign-
ments of seats with memory functions. The
memory keys can then be programmed again.