Cupra TERRAMAR 2024 - Main Beam Assist (Light Assist)

Lights
133
Vehicle lighting
●
The turn signal only works when the igni-
tion is switched on. The turn signals only
work when the ignition is switched on.
●
The main beam can only be switched on
when the dipped beam is switched on.
●
If a trailer turn signal fails, the indicator
light (trailer turn signals) stops ashing, in-
stead of ashing the turn signal at double
speed in the vehicle.
●
In cold or wet weather conditions, the
headlights, tail lights and turn signals may be
temporarily fogged from the inside. This is
normal and has no eect on the service life
of the vehicle's lighting system.
●
The parking light does not activate auto-
matically if the left- or right-hand turn signal
is left on and the ignition is disconnected.
Main beam assist (Light Assist)
The main beam assist automatically prevents
glare from vehicles moving in the opposite di-
rection or ahead in the same direction. In addi-
tion, the main beam assist detects illuminated
areas and disconnects the main beam head-
light when passing, e.g. by populated areas.
Within its limitations, the assist system auto-
matically connects or disconnects the main
beam headlight depending on the environ-
mental and traic conditions, as well as the
speed ››› .
Advanced main beam assistant (LED Matrix)
The advanced main beam assistant provides
maximum illumination of the road and road-
side. At the same time, it avoids dazzling vehi-
cles ahead or oncoming traic.
The system uses a camera to detect other road
users and deactivates certain areas within the
light distribution in a specic manner. If the
system cannot avoid dazzling other road users,
the main beam is switched o completely.
The advanced main beam assistant normally
recognizes illuminated areas such as cities
and deactivates the main beam while driving
through them.
Within the limits of the system, the assistant
automatically switches the main beam on or
o depending on the ambient conditions, traf-
c conditions and driving speed.
The advanced main beam assistant can be
switched on or o in the vehicle settings in the
Infotainment System.
Switching on the main beam assist or
advanced main beam assist (Matrix LED)
●
Switch on the ignition and select mode
on the headlight control ›››Fig.101.
●
From the neutral position, press the turn sig-
nal and main beam headlights lever forwards
›››Fig.102
3
.
When the main beam assist is switched on,
the control lamp on the instrument cluster
screen turns on. When the main beam is on,
the blue main beam control lamp on the
instrument cluster switches on.
Switching o the main beam assistant or ad-
vanced main beam assistant (LED Matrix)
●
Switching o mode on the headlight
control ›››Fig.101.
●
EITHER: if main beam assist is on, pull the
turn signal light and main beam headlights
lever back ›››Fig.102
4
.
●
OR: if the main beam assistant is on, but the
main beam does not turn on, press the turn
signal and main beam lever forwards to turn
the main beam on manually. Pull the turn sig-
nal and main beam lever back to switch o the
main beam manually, if necessary.
●
OR: switch o the ignition.
Additional functions
Depending on the equipment, the headlamps
are equipped with additional functions that im-
prove comfort and safety.
●
Lane light: If the system has detected that
the vehicle is travelling on a multi-lane motor-
way or similar roads the lane light illuminates
the full width of the driving lane. If vehicles
are detected ahead, the amount of lane illumi-
nated ahead of the vehicle reduces automat-