Cupra TERRAMAR 2024 - Welcome Light; Driving Abroad

Lights
135
Vehicle lighting
Turning on the “Leavinghome” light
●
Unlocks the vehicle (if the automatic dipped
beam function is switched on and the light
sensor detects darkness).
Turning o the “Leavinghome” light
●
It turns o automatically once the lights o
delay time has elapsed.
●
OR: lock the vehicle.
●
OR: press the light control as many times as
necessary until the instrument cluster displays
the setting .
●
OR: switch on the ignition.
Turning on the “Coming home” light
●
Switch the ignition o.
The “Coming home” light comes on if the au-
tomatic headlight control is switched on
and the light sensor detects darkness.
The lights-o delay countdown starts when
the last door or rear lid of the vehicle is closed.
Turning o the “Coming home” light
●
It switches o automatically after the set
lights-o delay time has elapsed.
●
EITHER: it is automatically deactivated if, 30
seconds after the function has been activated,
any vehicle door or the rear lid is still open.
●
OR
: press the light control as many times as
necessary until the instrument cluster displays
the setting .
●
OR: switch on the ignition.
“Cominghome” and “Leavinghome” set-
tings
The duration of the lights-o delay can be set
in the vehicle settings menu of the infotain-
ment system, where the function can also be
activated and deactivated ›››page40.
Welcome light
The welcome light is a light located on the
exterior mirrors facing the ground which is
switched on or o if the lights control is in
the
position and the “Coming Home” or
“Leaving Home” function is switched on or o.
The behaviour of the exterior lighting can be
set in the infotainment system. It is possible to
choose between two types of display:
●
Classic lighting: Background lighting, head-
lamps and tail lamps are switched on and o at
the same time.
●
Dynamic lighting: The background lighting,
headlights and tail lights turn on and o dy-
namically and, if applicable, with animation.
The access lighting when approaching the ve-
hicle can be activated or deactivated in vehi-
cles with a Keyless Access locking and ignition
system.
Dynamic headlight range control
The headlight range is automatically adjusted
according to the vehicle load status when they
are switched on.
WARNING
If the dynamic headlight range control fails
or does not work properly, the headlights
could dazzle and distract other road users.
This could cause accidents and lead to seri-
ous injuries.
●
Immediately go to a specialist workshop
and have the headlight range control system
checked.
Driving abroad
The light beam of the dipped beam lights is
asymmetric: the side of the road on which you
are driving is lit more intensely.
When a car that is manufactured in a country
that drives on the right travels to a country that
drives on the left (or vice versa), it is normally
necessary to cover part of the headlight bulbs
with stickers or to change the adjustment of
the headlights to avoid dazzling other drivers.
In such cases, the regulations specify certain
light values that must be complied with for
designated points of the light distribution. This
is known as “Tourist light”.