Cupra TERRAMAR 2024 - Revolution Counter

18
Driver information
1)
Depending on version.
2)
Only in the CUPRA view on the instrument cluster.
●
Other travel data: km travelled and driving
time. By pressing the arrow on the left of the
multifunction steering wheel, you can switch
between the dierent memories of the travel
data.
●
Assist systems.
●
Engine power and torque.
●
> (close classic view).
CUPRA view
Turning the right hand thumbwheel on the
multi-function steering wheel scrolls through
the following information displayed in the mid-
dle of the rev counter:
●
Speed and gears.
●
Lap timer.
The following information is displayed outside
the rev counter circle:
●
Right-hand area: G-force meter.
●
Left-hand area: engine power and torque.
Revolution counter
The rev counter indicates the number of en-
gine revolutions per minute.
Together with the gear-change indicator, the
rev counter oers you the possibility of using
the engine of your vehicle at a suitable speed.
The beginning of the red zone of the rev coun-
ter indicates the maximum speed in any gear
after running-in and with the engine hot. How-
ever, it is advisable to move the selector lever
to D or lift your foot o the accelerator before
the needle reaches the red zone ››› .
We recommend that you avoid high revs and
that you follow the recommendations on the
gear-change indicator. See the additional in-
formation in ›››page160, Selecting the op-
timal gear.
Speed limiter
1)
If the Indicator light
turns on, the engine will
be automatically limited to the speed shown on
the instrument cluster. This protects the en-
gine components in situations such as a cold
start or against overheating.
The engine speed limiter is released as soon as
the engine reaches normal operating temper-
ature and the takes his/her foot o the accel-
erator.
If the engine speed limitation is caused by an
engine management fault, the indicator
lamp also lights up. Make sure the displayed
RPM is not exceeded (for example, by reducing
it). Go immediately to a specialised workshop
to have the fault repaired.
Flashing indicator
1)2)
The ashing indicator warns the driver that the
engine RPM limit has been reached.
The ashing indication is displayed in the up-
per areas of the rev counter by green, yellow
and red areas.
When the RPM approaches the limit, the ash-
ing indicator ashes red. Shift up a gear at the
right time.
NOTICE
●
To prevent damage to the engine, the rev
counter needle should only remain in the red
zone for a short period of time.
●
When the engine is cold, avoid high revs
and heavy acceleration and do not make the
engine work hard.
For the sake of the environment
Changing up a gear early will help you to
save fuel and minimise emissions and engine
noise.