Cupra TERRAMAR 2024 - Store the Rear Shelf; Variable Luggage Compartment Floor

314
Storing objects
Store the rear shelf
Fig.183 In the luggage compartment:
remove covers to accommodate the rear
shelf in the luggage compartment.
Fig.184 In the boot: tting the rear shelf.
Depending on the equipment, once the lug-
gage compartment shelf has been removed, it
can be stored under the luggage compartment
oor.
●
Remove the left and right covers
1
and store
them in the compartments under the oor
›››Fig.183.
●
Place the rear shelf in the corresponding
housing ›››Fig.184.
Variable luggage compartment
oor
Variable oor in high position
Fig.185 Variable luggage compartment
oor: high position.
●
To move from the low position to the
high position, lift the oor using the handle
›››Fig.185
1
, and pull it back until the
front of the oor has fully passed the supports
›››Fig.186
2
.
●
Move the oor forward over the supports as
far as the rear seat backrest and then lower the
oor with the handle
1
.
Variable
oor in low position
Fig.186 Variable luggage compartment
oor: low position.
●
To move from the high position to the
low position, lift the oor using the handle
›››Fig.185
1
, and pull it back until the
front of the oor has fully passed the supports
›››Fig.186
2
.
●
Now let the front part fall to the oor and
slide the oor forwards as far as the rear seat
backrest; lower the oor at the same time with
the handle
1
.
Note
CUPRA recommends returning the variable
oor to the high position ›››Fig.185 when
additional space is no longer required.