Cupra TERRAMAR 2024 - Energy Management; Optimisation of the Starting Capacity

368
Checking and relling levels
●
Stop driving! Stop the vehicle immedi-
ately, taking into account the traic situation.
●
Choose a safe place outdoors, away from
buildings or vehicles, canopies, covered car
parks or similar places.
●
If possible, switch on the hazard warning
lights.
●
Before leaving the vehicle, make sure it is im-
mobilised (parking brake, parking lock P).
●
Switch o the ignition and leave the ignition
key on the dash panel or in a visible place so
that the emergency services can use it (for ex-
ample to recover the vehicle from a hazardous
area).
●
Exit the vehicle and make sure that there are
no other people or animals left inside.
●
Make sure that you leave the danger zone to-
gether with all other occupants of the vehicle
and that everyone remains in an area that is
protected from traic (e.g. behind the guard
rail).
●
Notify the emergency services.
48-volt battery
The indicator lamp lights up red while driving.
The following message is displayed:
Error: 48V power supply. Stop the vehicle
safely! Please refer to the instruction man-
ual.
There is a error in the 48V power supply.
1. Park the vehicle in a safe place.
2. Stop the engine and turn o the ignition.
3. Wait for a few seconds.
4. Switch ignition back on.
5. Start the engine.
If the lamp remains on, seek professional assis-
tance. To do so, CUPRA recommends going to
a CUPRA dealer or any SEAT dealership.
48-volt battery
When the vehicle is stopped, the warning lamp
lights up yellow and the following message is
displayed:
Error: 48V power supply. Do not start driv-
ing. Please refer to the instruction manual.
There is a error in the 48V power supply.
1. Park the vehicle in a safe place.
2. Stop the engine and turn o the ignition.
3. Wait for a few seconds.
4. Switch ignition back on.
5.
Start the engine.
If the lamp remains on, seek professional assis-
tance. To do so, CUPRA recommends going to
a CUPRA dealer or any SEAT dealership.
48-volt battery
When the vehicle is stopped, the warning lamp
lights up yellow and the following message is
displayed:
48V battery charge low. Start the engine or
refer to the owner's manual.
48V Battery state of charge warning.
1. Start the engine.
2. Stand in a safe place and leave the engine
running for a few minutes.
If the lamp remains on, seek professional assis-
tance. To do so, CUPRA recommends going to
a CUPRA dealer or any SEAT dealership.
If the engine cannot be started:
1. Switch the ignition o.
2. Use the Jump start ›››page338.
If the vehicle still won’t start, seek professional
assistance. To do so, CUPRA recommends go-
ing to a CUPRA dealer or any SEAT dealership.
Energy management
Optimisation of the starting ca-
pacity
Energy management controls the electrical
power distribution so that there is always
enough electrical power to start the engine.