Cupra TERRAMAR 2024 - Page 88

86
High-voltage battery
Low state of charge in the high-voltage
battery
The control lamp switches on yellow. A mes-
sage is displayed showing the remaining range.
The high-voltage battery charge has reached
the reserve level.
●
Charge the high-voltage battery.
Failure in the range calculation
The control lamp switches on yellow. A mes-
sage is displayed.
There is a fault in the range calculation. Con-
tact a specialised workshop.
The charging process is not possible or has
been paused
The charging process indicator located next to
the charging socket lights up red.
Before visiting a specialist workshop, you can
try the following solutions:
●
Plug the charging cable back in.
●
Check that the charging connector is plug-
ged in correctly.
●
Check if a fault is displayed on the charging
station or, depending on the equipment, on
the charging cable protection device.
If the fault cannot be rectied, contact a spe-
cialist workshop immediately.
The charging cable protection device dis-
connects
If electrical devices with a separate electrical
connection, e.g. a cool box, are used in the
vehicle at the same time, the self-test of the
protective device may detect a fault.
●
Please note the order! First connect the
charging cable to the external power supply
and then to the charging socket.
The charging time varies
During the direct current (DC) charging proc-
ess, the charging current is reduced automat-
ically to preventing the high-voltage battery
from overheating.
After several fast charging processes in a row,
the charging time is temporarily extended.
WARNING
High-voltage components, including the bat-
tery and high-voltage cables, may be live and
damaged. The high voltage system voltage is
dangerous and can cause burns, other inju-
ries and fatal electric shocks.
●
Do not touch the high voltage compo-
nents!
Emergency release of the charging
connector
Valid for: hybrid vehicles
Fig.63 Between the left wing panel and the
engine bonnet hinge: Charging connector
manual emergency release cover.
Unlocking the charging connector
Prerequisites:
●
The charging connector is plugged in cor-
rectly.
●
The vehicle is unlocked.
●
The charging process has ended or has
paused ›››page79.
●
When charging with alternating current
(AC), the setting Release connector auto-
matically is activated in the infotainment sys-
tem. ›››page87.