CURAPROX HYDROSONIC ORTHO - Charging and Battery Management; Understanding Charge Levels; Charging Procedures; Battery Life and Charging Tips

THE BASICS
Choose your brush head
• «sensitive» and «power» for normal brushing.
• «single» for contact points with orthodontic devices,
from brackets and lingual brackets to retainers;
and for caring for the gum line.
The brush heads are easy to attach and remove.
Caution: Do not bend.
Switch on and o
Press button briey.
Mode selection
Press and hold button; release at desired mode. When you
turn it on, the Hydrosonic Ortho will start on the last
selected mode. Bristle movement will automatically and
immediately slow down when too much pressure is used.
Press briey:
on/o
Charging: Use the charger or the USB port on your
laptop/computer.
Press and hold:
Mode selection
CHARGING STATUS:
ALWAYS AT FULL POWER
• The Hydrosonic Ortho is delivered 75 % charged.
You can use it immediately.
• You can see the charge status when you remove the
Hydrosonic Ortho from the charger or switch it o.
• When all seven LEDs on the display light up, the battery
is fully charged: the more the LEDs light up, the more
charged the battery.
• If the bottom LED is red instead of blue, the battery is
less than 20 % charged.
• To charge, place the Hydrosonic Ortho into the charger,
which should be connected to the mains: plug the USB
plug into the charger’s USB connection, and plug into
the mains. You can also charge the device using the
USB port on your laptop or computer.
• Once fully charged, the battery will last a good
60 minutes, which equates to two weeks of brushing for
four minutes each day.
• Optimal battery charging time: 10 hours. For extra-long
life: Charge your toothbrush only when the battery
status falls below 20 % (the red LED will indicate this).
• Always at full power: cleaning performance does
not change as the battery runs out. The Hydrosonic
Ortho cleans just as well on low battery as when it’s
fully charged.
30 31