12V / 24V, 4A Chargers 12V, 8A Chargers 24V, 8A Chargers
Nominal Operating Voltage 120VAC 230VAC 120VAC 230VAC 120VAC
230VAC
Input Voltage (VAC) 90 - 132 180 - 264 90 - 132 180 - 264 105 - 132
210 - 264
Operating Frequency (Hz)
47 - 63
Input Current (A
rms
,
max.)
12VDC nominal outputs
1.0 @
90V/60Hz
0.5 @
180V/50Hz
2.0 @
90V/60Hz
1.0 @
180V/50Hz
24VDC nominal outputs
2.0 @
90V/60Hz
1.0 @
180V/50Hz
4.0 @
105V/60Hz
2.0 @
210V/50Hz
Input Leakage
(µA, max.)
<500 @
120V/60Hz
<500 @
230V/50Hz
<500 @
120V/60Hz
<500 @
230V/50Hz
<500 @
120V/60Hz
<500 @
230V/50Hz
Output Power (W, nom./max.)
12VDC nominal outputs
24VDC nominal outputs
48 / 67.5
96 / 135
96 / 125
192 / 240
Output Current (A, max.) 4.0
N/A N/A
N/A N/A
8.0
Output Voltage (VDC, nom./range)
12VDC nominal outputs
24VDC nominal outputs
12 / 6.0 - 15.0
24 / 12.0 - 30.0
TECHNICAL SPECIFICATIONS
2.1 Electrical
2.2 Mechanical
Case: Aluminum alloy, black finish
End caps: Polycarbonate, black
Dimensions (mm max.):
1604CS & 1604FV: 160 L x 96 W x 52 H
1608FS: 160 L x 140 W x 52 H
Weight (kg) 1604/1608: 1.0/1.5
2.3 Connections
AC Power Inlet: IEC 320/C14 Male on cable
DC Power: ITT Cannon XLR-3-12C Male Plug or equivalent on cable
P
in Function
1B+
2B-
3Motor Controller Charging Indicator
Programming Port: Molex 39-01-2040 with four female crimp terminals
(Molex 39-00-0056). Use with Curtis Model 1311 Hand
Held Programmer only.
P
in Function
1Rx
2 SEC_RTN
3 Tx
4 +12V
Output Adapters:
P/N 17604348-1 for use with P/N 17604348-2 for use as
Model 1288 Motor Controller ISO-7176 compliant Off-board Charger
P
in Function Pin Function
1Motor Controller 1 B+
Charging Indicator 2 B-
2 B+ 3 B- (inhibit)
3 N/C
4 N/C
5 B-
6 N/C
Charge Indicator: Low impedance capable of sinking 60 mA DC to B-.
Remote LED: Some models come with a wire harness for remote LED capability.
Contact your local Curtis sales office for details.
Curtis 1604/08 Manual
page 2
To Next Page
Loading...