2
PROGRAMMING THE ILGD & TL-ILGD GRINDER
Your grinder has been adjusted at the time of manufacture to provide satisfactory performance in most situations. In
the event that you would like to vary the settings the grinder can be reprogrammed. Both grinders are programmed
identically.
1. Place a paper filter beneath the grinder spout to catch coffee as it
is ground.
2. Turn off the unit at the front panel, ON/OFF button.
3. Press and hold one of the grind buttons.
4. Press and release the ON/OFF button. Continue holding the grind
button.
5. In the red window, the grind time on the button pressed will
appear. Continue to hold and the time digits will start at
0000
0000
00 and
increase. Release the button to set the new time. The table
(left)can be used as a guide to estimate the amount of ground
coffee you dispense with the chosen setting.
6. Wait for the motor to completely stop (10 seconds). To set and
exit, press and release any other grind button.
7. Repeat the above steps to reset any other grind button.
PROGRAMMING THEPROGRAMMING THE
PROGRAMMING THEPROGRAMMING THE
PROGRAMMING THE
GRINDERGRINDER
GRINDERGRINDER
GRINDER
1.3
1.5
1.8
2.0
2.5
3.0
3.7
4
5
6
7
8
10
12
15
20
25
30
35
40
45
4.5
6.2
7.6
8.8
10.0
11.8
13.5
Seconds OuncesSeconds Ounces
NOTE:NOTE:
NOTE:NOTE:
NOTE: Time settings in
this table are only
approximate. Amounts
will vary with grind texture and
specific coffee bean. Weigh your
output, then make adjustments as
necessary
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
MOTOR CRUSHING GRINDER ASSY 120VAC
MOTOR, GRINDER 120VAC
CAPACITOR, COFFEE GRINDER ASSY
SHEAR DRIVE COFFEE GRINDER
SHEAR DISK
CAP, SHEAR DISK GRINDERS
COVER, GRINDER HOUSING W/LABEL
SCREW & THRUST PIN ADJUSTING ASSY
SPRINGBAFFLE LONG, NITRIC ACID COLORING
SPRING BAFFLE SHORT, NITRIC ACID COLORING
BAFFLE, SPOUT
SPOUT, GRINDER HOUSING
BURRS, SET CRUSH HIGH FLOW
SPRING, TENSION COFFEE GRINDER
WORM FEEDING ASSY CCG
WC-9135
WC-91022
WC-91026
WC-91024
WC-91025
WC-91016
WC-91017
WC-91015
WC-91029
WC-91027
WC-91028
WC-91023
WC-91045
WC-91021
WC-91020
DESCRIPTIONITEM PART N°
9
10
11
12
13
14
15
B
ILLUSTRAILLUSTRA
ILLUSTRAILLUSTRA
ILLUSTRA
TED PTED P
TED PTED P
TED P
ARAR
ARAR
AR
TSTS
TSTS
TS
LISTLIST
LISTLIST
LIST
GRINDER MOTOR
A
5
2
3
8
6
4
7
B
11
11
1
To Next Page
Loading...