Curtis LCD1992A - Connections: Antenna and External Equipment; Antenna Connection Procedures; External Equipment Connection Guide; USB Connection and Media Playback

17
CONNECTIONS & SETUP
1. Connect the AV jacks between TV and external equipment. Match the jack colors
(Video = yellow, Audio Left = white, and Audio Right = red).
2. Select AV source with using the SOURCE/ button on the remote control.
3. Operate the corresponding external equipment. Refer to external equipment
operating guide.
EXTERNAL EQUIPMENT CONNECTIONS
V i d e o Ga m e S e t
PHIL IPSPHIL IPS
DRIVEDRIVE
TURBOTURBO
C a m c or d e r
AV
USB CONNECTION
USB
Note:Can only support MP3 format of music
16
CONNECTIONS & SETUP
ANTENNA CONNECTION
■For optimum picture quality, adjust antenna direction.
■An antenna cable and converter are not supplied.
■To prevent the equipment damage, never plug in any power cords until
you have finished connecting all equipment.
■In poor signal areas, to get better picture quality, install a signal amplifier
to the antenna as shown below.
■If signal needs to be split for two TVs, use an antenna signal splitter for connection.