- 35 -
Problems Solutions
SWITCHING A
CHANNEL OR
SOURCE CHANGES
THE VOLUME
Different channels and inputs will sometimes have this effect
because the channel signal’s own volume is already loud.
There is no way remove this completely. The TV has an
AUTO VOLUME LEVEL function that can combat this type of
effect. Please make sure that function is turned on.
THERE IS NOISE OR
TRASH PIXELS ON
THE SCREEN
When your TV’s resolution is higher than the digital channel’s
broadcast resolution, the signal is up-converted to match your
TV’s resolution. Up-converting can cause this type of effect.
TIPS FOR HIGH
DEFINITION USERS
The TV is an ideal platform for viewing High Definition
Content. The best image quality can be achieved by HDMI,
YPbPr (Component), then VGA. However, due to variances in
broadcast practices, it is possible some image distortions can
occur.
TIPS FOR
LETTERBOX
CONTENT USERS
Letterboxed (Widescreen) versions of DVD movies are most
commonly formatted for standard 4:3 TVs. The TV has the
capability of expanding this content so the entire screen is
filled at the expense of the image proportion. To use this
function press the aspect button on the remote control and
cycle among the available options.
I CANNOT FIND THE
VOLUME AND
CHANNEL
CHANGING
BUTTONS
The buttons are represented by the ▲▼◄► buttons located
on the remote control. ▲▼ changes the channels and ◄►
changes the volume.
TV TURNS OFF
AUTOMATICALLY
AFTER 10 MINUTES
The TV features a power saving mode which will automatically
turn off the TV, if there’s no signal provided for more than 10
minutes.
To Next Page
Loading...
Need help?
General
