Need help?Do you have a question about the Curtis RT700 and is the answer not in the manual?
General| Brand | Curtis |
|---|---|
| Model | RT700 |
| Category | Portable TV |
| Language | English |
Connect the antenna to the ANT jack for receiving CATV/ANT signals.
Connect AV cable to AV IN jack and use AV/TV button to enable external audio/video.
Connect headphones to the headphone jack for private listening. Speakers will mute.
Connect AC adaptor or car adaptor to the power source input jack.
Press the POWER button to turn the unit on or off. Power light indicates status.
Use MENU/PIC/SETUP/TUNE buttons to access Picture, Function, and Preset menus.
Switch between VIDEO input from external sources and TV tuner input.
Press MUTE to silence audio output. Press again to resume volume.
Use VOL up/down buttons to adjust the unit's volume level from 0-63.
Use CH up/down buttons for channel selection, and numerical buttons for direct input.
Adjust Brightness, Contrast, Color, and Tint settings via the Picture menu.
Manage preset channels, including skipping or adding channels using PROG and SKIP functions.
Use the FINE feature to adjust the frequency of each channel for better sound and picture.
Select ANT for antenna or CATV for cable TV to optimize reception up to 136 channels.
To Next Page
