Curtis TP2S63A3100 User Manual

CLEANING INSTRUCTIONS CI5
("--0/5)&3."-%*41&/4&3$-&"/*/(*/4536$5*0/4ø D
 Disassemble the faucet - Unscrew the handle/
bonnet assembly from the top of the faucet and
remove it. Inspect the seat cup for wear. Replace the
seat cup if it is damaged.
%JTBTTFNCMFUIFTJHIUHBVHFTPNFWFSTJPOT
Unscrew the cap and guard to dis-assemble.
Remove the glass tube. Inspect it for cracks or
chips. If broken, replace the glass with a new one.
9 Air Dry - Turn the container and lid upside down
and allow to air dry.
Cleaning the Faucet Parts and Site Gauge
10 Wash - Wash allGBVDFUBOEHBVHFHMBTTQBSUTJG
BQQMJDBCMFXJUIUIFEFUFSHFOUTPMVUJPO$MFBOUIF
inside of the gauge glass with a gauge brush soaked
with detergent solution.
11 Rinse - Thoroughly rinse all parts with clean, warm
water.
 Sanitize - After rinsing, place all faucet and gauge
parts in a sink to be sanitized. Immerse them in One-
1SPDMFBOFSNJYFEBUBSBUJPPGP[HQFSHBM
-PGIPUXBUFS¡'¡$NJO"MMPXUIFQBSUT
to soak for 15 minutes.
13 Air Dry - Remove the faucet parts from the
sanitizer, rinse thoroughly and allow them to air dry.
14 Reassemble - When dry, reassemble the handle/
bonnet. Hand tighten the handle/bonnet onto the
top of the faucet assembly, reinstall the site gauge
JGBQQMJDBCMF*GSFQMBDJOHBCSPLFOHBVHFHMBTT
carefully remove any traces of glass from the silicone
parts before inserting the new gauge glass tube.
Reinstall the lid.
WASH
RINSE
SANITIZE
Cleaning the Thermal Dispenser (cont.)
Faucet
Assembly
Style varies
Seat cup
Handle
Bonnet
Cap
Lid
Washer
Washer
Guard
Glass tube
Float

Curtis TP2S63A3100 Specifications

General

Brand	Curtis
Model	TP2S63A3100
Category	Brewing Systems
Language	English