Curtis WB5GT Series - Programming Guide; Temperature and Display Settings; Energy Saver Mode Configuration

PROGRAMMING GUIDE PG16
8$130(3"..*/((6*%&ø
$
Programming Options
Temperature (default is 204°F/96°C)
Press the TEMP button for one second to check the control panel water temperature setting. To change
the temperature setting, press the TEMP button for three seconds, then release, to enter temperature
QSPHSBNNJOHNPEF5IFUFNQFSBUVSFTFUUJOHSBOHFJT'UP'1SFTTUIFMFGUCVUUPOŻ) or the right
CVUUPOŹ) to lower or raise the temperature. Press ON/OFF) to save and exit.
HOT - Changing the display to read HOT, instead of the current temperature
Press and hold the TEMPCVUUPOGPSmWFTFDPOET5IFi'wXJMMTUBSUnBTIJOH$POUJOVFIPMEJOHEPXOUIFTEMP
button, at the same time, press and hold the ON/OFF CVUUPOGPSmWFTFDPOET3FMFBTFCPUICVUUPOT
5IFQSPHSBNJTOPXDIBOHFEBOEUIF-&%TDSFFOXJMMEJTQMBZi)05w8IFOi)05wJTEJTQMBZFEQSFTTJOHUIF
TEMP button for one second will display the current water temperature.
°F/°C - Changing the display to Celsius (or changing back to Fahrenheit)
Press and hold down the TEMPCVUUPOGPSTFDPOET5IFUFNQFSBUVSFSFBEJOHXJMMDIBOHFUP$FMTJVTPS
'BISFOIFJU3FMFBTFUIFTEMP button.
Energy Saver (default is OFF)
• 8IFOFOFSHZTBWFSJTTFUUPi0''wUIFVOJUDPOUJOVPVTMZNBJOUBJOTUIFUFNQFSBUVSFTFUUJOHQSPHSBNNFE
into the control panel.
• 8IFOFOFSHZTBWFSJTTFUUPi0/wUIFIFBUJOHFMFNFOUTTIVUPGGGPVSIPVSTBGUFSUIFMBTUEJTQFOTF
• 8IFOFOFSHZTBWFSJTTFUUPi¡'wUIFVOJUXJMMCFHJOUPNBJOUBJOUIFXBUFSUFNQFSBUVSFBU¡'GPVS
hours after the last dispense.
• 5PSFUVSOUIFVOJUUPOPSNBMPQFSBUJPOBGUFSUIFVOJUIBTHPOFJOUPFOFSHZTBWFSNPEF0/PS¡'QSFTT
one of the control panel buttons or dispense some water.
To change the energy saver setting
Press and hold both the ON/OFF
) and TEMPCVUUPOBUUIFTBNFUJNFGPSTFDPOET6TFUIFTDSPMM
buttons, Ż and ŹCVUUPOTUPTFMFDUi0''wi0/wPSi¡'w1SFTTON/OFF
) to save and exit.
READY
ON/OFFTEMP AERATION
READY
Control Panel - WB5GT Series Control Panel - WB5N Series
IMPORTANT: The Fahrenheit/Celsius setting cannot be changed while the unit is set to display “HOT”. Set
WKHXQLWWRGLVSOD\WKHWHPSHUDWXUHÀUVWEHIRUHFKDQJLQJWKHWHPSHUDWXUHVFDOH