BOOM IDENTIFICATION
Here are the 5 boom sections with measurements displayed for the pre-drilled holes. You
won’t need these measurements, they are just there to identify the correct tube placement
and orientation. Identify each tube by where the holes are. Once you have identified the
tubes, determine which end of the tube will insert into the middle boom section. Mark this
side of the tube 3 inches from the end. This mark will be used to set the insertion depth
into the middle boom section. If the tubes are put together incorrectly, the elements will be
out of place and the antenna will not work properly.
Rear of antenna
(holes close together)
Rear Boom Section
Middle Boom Section
Front Boom Section
2.25 8 14.5 26
1-1/4 X .035 X 40 4 HOLES
5.75
38.75
1-1/2 X .058 X 72 WITH INSERT 2 HOLES
1-3/8 X .058 X 65
4.25
38.625
1-3/8 X .058 X 72 2 HOLES
5.125
37.75
1-1/4 X .035 X 40 2 HOLES
17.6254.75
43.75
1-3/8 X .058 X 72 3 HOLES
Rear Mid boom section
Front Mid Section
MARK 3 INCHES FROM END
MARK 3 INCHES FROM END
MARK 3 INCHES FROM END
MARK 3 INCHES FROM END
FRONT OF ANTENNA
To Next Page
Loading...
