Tape coax to boom
and mast when mounted
at its final loacation
The antenna is now ready for mounting on your pole or tower. Route the coax along the boom
and mast. Secure it using cable ties or electrical tape. Check the antenna over one last time to
make sure everything is in place and secure. If you haven’t already, Place the plastic end caps
over the end of the booms.
ALWAYS have a friend over to help you install the antenna. The antenna is very lightweight
but it is awkward to handle.
NEVER try to install this antenna near power lines or place it anywhere that it can contact
power lines if it were to fall.
Antenna shown in vertical position
for Illustration only.
To Next Page
Loading...
